Portal-Operation-Manual-REV-I.pdf - 第18页
PVA Portal Manual Revision I / Janua ry 2022 Page 18 of 106 5.1 Cycle Stop Inte rface Figure 4 : Cy cle Stop Interf ace After logging in , sel ect “ Continue ” . Portal will o pen in Cycle Stop mode, which is the default…
PVA Portal Manual
Revision I / January 2022
Page 17 of 106
Portal Overview
The Portal screen has several components. Understanding the sections of the Portal
screen will ensure successful navigation of the Portal program.
Figure 3: Portal Screen Overview
• Select the desired mode from the mode selection area.
Note: Cycle Stop mode must be selected in order to change to a new mode.
• Upon selecting a mode, the options for that mode will be shown in the mode display
section of the screen.
• The System Tabs section of the screen remains the same no matter what mode is
selected. This section of the screen contains the terminal used to communicate
with the controller. The Terminal is used as a debug tool.
PVA Portal Manual
Revision I / January 2022
Page 18 of 106
5.1 Cycle Stop Interface
Figure 4: Cycle Stop Interface
After logging in, select “Continue”. Portal will open in Cycle Stop mode, which is the
default mode for the workcell. All other modes and options can be accessed from this mode
with the buttons shown.
1. Select the “Auto” button to operate the machine in Auto Cycle. Refer to Section 7
for more information.
2. Select the “Stop” button to go to Cycle Stop mode from any other mode. Refer to
Section 5.1 for more information.
3. Select the “Manual” button to operate the machine manually. Refer to Section 6 for
more information.
4. Select “Setup” to see or change the setup functions of the machine. Refer to
Section 8 for more information.
1
7
9
8
2
3
4
5
6
PVA Portal Manual
Revision I / January 2022
Page 19 of 106
Note: To change from one mode to another, the “Stop” button must be selected. For
example, to go from Manual mode to Auto Cycle mode select the “Stop” button and
then select the “Auto” button. The Cycle Stop mode must be selected to shut down
Portal.
5. Select the desired program to use while in Auto Mode from the Program Selection
dropdown menu. Refer to Section Error! Reference source not found. for more
information.
6. Select the “Quit” button to shut down Portal.
7. All system messages will be shown in the Messages From Controller window.
8. To change the User, select Cycle Stop and select the User at the bottom of the
window.
Figure 5: User Options
9. The Linked display shows the machine status. This indicator will blink while the PC
is connected to the workcell, but NOT while the machine is in an error state.
Figure 6: Linked Display
5.2 Program Selection
The active program can be changed at any time with the Program Selection drop-down
menu. Refer to Sections 14.1 and 14.2 for more information.