MD600 Series Compact AC Drive Hardware Guide-EN-B06.PDF - 第82页
Shipment Check ‑81‑ 7 Shipment Check Procedure 1. Open the package and check whether the drive is intact. If the AC drive or other accessories are damaged, do not operate or install the damaged device. 2. Check whether t…
Wiring
‑80‑
6.6 Post-wiring Inspection
After wiring is done, check the following items and tick compliant items.
Table 6–7 Post-wiring inspection checklist
No. Item
Tick
1
The power supply input cables are connected to the R, S, and T
terminals (three-phase 380 V) or L1 and L2 terminals (single-phase
220 V).
□
2
Motor input cables are connected to the U, V, and W terminals.
□
3
The cross-sectional area of the main circuit cables meet the
requirements.
□
4
The heat-shrink tubing has been applied to the copper barrel of the
main circuit lug and cable conductors, with the tubing fully covering
all exposed conductors.
□
5
The motor output cable does not exceed 50 m. Otherwise, the
carrier frequency needs to be reduced through A5-01.
□
6
The grounding cable is connected properly.
□
7
The output terminals and control cable terminals are connected
properly.
□
8
The braking resistor and braking unit with proper resistance are
wired properly.
□
9
The control circuit signal cables are shielded twisted pair cables.
□
10
Control circuit cables and main circuit cables are routed through
different routes.
□
11
There are no screws, gaskets, or exposed cables left inside the
product.
□
12
When wiring multiple motors, ensure the connections are correct
and avoid cross-wiring between the motors and the drive. Cross-
wring may cause abnormal motor operation.
□
Shipment Check
‑81‑
7 Shipment Check
Procedure
1. Open the package and check whether the drive is intact.
If the AC drive or other accessories are damaged, do not operate or install the damaged
device.
2. Check whether the drive model is consistent with that on the delivery order.
3. Record the model and serial No.
Power Supply Compatibility Check
‑82‑
8 Power Supply Compatibility Check
Check and ensure that the voltage of the mains power is compatible with the voltage of
the AC drive power supply.
The following table describes the AC drive models and power supply voltage.
Table 8–1 AC drive models and power supply voltage
Rated voltage
AC drive model
Single-phase 200 V to 240 V
MD600S/A-2S2R8
MD600S/A-2S4R6
MD600S/A-2S7R5B
MD600S/A-2S010B
Three-phase 380 V to 480 V
MD600S/A-4T1R6
MD600S/A-4T2R3
MD600S/A-4T4R8
MD600S/A-4T5R5B
MD600S/A-4T9R5B
MD600S/A-4T013B
Note
MD600S indicates the RS485 model, and MD600A indicates the CAN model.