00191913-01.pdf - 第515页
User Manual SIPLACE 80S-20/F4 11 Station extensions / hardware Software vers ion SR.406.xx 0 2/2000 Issue US 11.11 Feeder position recognition 513 If the cluster data contains an entry for a track, the PCB came ra on the…
11 Station extensions / hardware User Manual SIPLACE 80S-20/F4
11.11 Feeder position recognition Software version SR.406.xx 02/2000 Issue US
512
11.11 Feeder position recognition
11.11.1 General
A feeder can be measured if it is equipped with position fiducials. 11
This function can also be used with the waffle tray holder (manual tray) if it has position fiducials. 11
If the ‘Feeder position recognition’ function is selected on the line computer, this function will ap-
pear in the machine options. 11
You can then activate or deactivate feeder position recognition at each station from the machine
options. 11
.
Fig. 11.11 - 1 Feeder position recognition
PLEASE NOTE:
The ‘feeder position recognition’ function is always inactive when the station is switched on. 11
User Manual SIPLACE 80S-20/F4 11 Station extensions / hardware
Software version SR.406.xx 02/2000 Issue US 11.11 Feeder position recognition
513
If the cluster data contains an entry for a track, the PCB camera on the feeder moves to the posi-
tion of the centering fiducial. Any centering fiducial offset determined by measurement is allocated
to this track, and added to the pick-up position during the pick-up process. 11
11.11.1.1 Restrictions
– Feeder position recognition cannot be used for WPC trays that are set up in the wafflepack
changer.
– Up to three fiducial positions can be defined for each feeder.
– Feeder fiducials on the right-hand side of the table (viewed in the transport direction) cannot
be measured on the 80F.
PLEASE NOTE:
This restriction does not apply to machines with a “sub-gantry camera”. 11
– If there is a feeder at location 118, and the fiducial position of the outer pick-up division is closer
to the X-axis travel range limit than the pick-up position, then the 8 mm S tape and bulk case
feeder cannot be scanned.
11
11 Station extensions / hardware User Manual SIPLACE 80S-20/F4
11.12 Fine calibration Software version SR.406.xx 02/2000 Issue US
514
11.12 Fine calibration
11.12.1 Overview
Fine calibration involves measuring the machine’s placement offset and determining the required
correction from this value. The ‘Fine calibration’ measuring program is integrated into the SITEST
program, and a detailed description of the measuring procedure is given in the ‘Fine calibration’
instructions (article no. 00191655-01). 11
CAUTION
The SITEST program is password-protected. It must only be called up and used by Siemens en-
gineers or appropriately trained personnel. 11
11.12.2 System requirements
The following system requirements must be fulfilled in order to use the fine calibration program:11
Machine type S2x, F
4 or later
Station computer software version 406.xx or later
SITEST version 406.xx or later
11.12.3 Measuring equipment and tools
The following are supplied as standard: 11
– Mapping plate (glass plate in a metal frame)
– Double-sided transparent adhesive film
– Lighting unit
– Magazine with glass components for the revolver head and Pick&Place head with fine-pitch
vision module.
11
The following items must be ordered: 11
– Manual tray (waffle tray holder) to hold the magazine for the glass components
(article number 00116430-xx)
11
11