MAN00000772_SI-G200BB_SVCPDFA.pdf - 第254页
Calibration HLGB-10312-01 Checking Pickup Positio n SHEET 1/4 Checking Pickup Position Check pickup posit ions at three locations of casset te tables (Z101 、 Z120 、 Z140) on th e front side, and three locations of casset…
Calibration
HLGB-10311-01
Pickup Position Setup
SHEET
9/9
3. Click the Update button.
X, Y, H position data for parts pickup position is
updated.
4. Check that the front position data
value was updated.
The above completes pickup position setup.
Subsequently, check that pickup position has
been correctly set up according to a procedure in
the “Checking pickup position” in the ext item.
Calibration
HLGB-10312-01
Checking Pickup Position
SHEET
1/4
Checking Pickup Position
Check pickup positions at three locations of cassette tables (Z101、Z120、Z140) on the front side, and
three locations of cassette tables (Z101、Z120、Z140) on the rear side.
[Necessary jigs]
• Pickup point Jig
• Length reference nozzle jig
[Procedure]
1 Set the jig.
1. Set pickup point jig to Z101 on the
cassette table.
There should be no gap between the feed
adjusting jig and the cassette table.
2. Install the length reference nozzle jig
to the turret No.1.
When installing the nozzle, insert it while
slowly turning.
After inserting the nozzle, check that it is not
drawn out by pulling downward.
Pickup point Jig
Length reference
nozzle jig
Length reference
nozzle jig
Pickup point Jig
Calibration
HLGB-10312-01
Checking Pickup Position
SHEET
2/4
2 Display a Front/All Cass. Pos. Teaching by
Tools screen.
1. Click in an order of M/C SETUP menu
PARTS SUPPLY tab.
PARTS SUPPLY screen is displayed.
2. Click the Teaching button on the Front
Pos. Data to display a drop down
menu.
3. Click the Jigs in the drop down menu.
The Front/All Cass. Pos. Teaching by Tools
screen is displayed.
3 Set the tool located cassette No.
1. Click the #1 and input “101” in input
box for Tool Located Cass.
2. Click the #2 and enter “120” in the
input box for Tool Located Cass.
3. Click the #3 and input “140” in input
box for Tool Located Cass.
4 Display a Move screen.
1. Click the #1.
2. Click the Move button.
Move screen is displayed.