MAN00000772_SI-G200BB_SVCPDFA.pdf - 第26页
Setting UPS w h e n exchanging h a r d disk Setting UPS when exch anging hard disk UPS re-setting is re quired when hard disk is replace d. [Close H I] 1. Change user level to SER VICE. Click Key mark o n the left side s…
Work Procedure
WKGB-10102-01
G200BB Head Maintenance
SHEET
11/11
11 Secure the mask plate with 4-CP2.5X5.
Attach the mask plate after attaching all the
bottom bearings to the Indexes.
12 Attach the O-ring holder with 3-CP2.5x8.
Make sure to attach the O-ring holder in the
correct orientation.
13 Attach the small gear and adjust the phase.
For small gear attachment and phase adjustment procedure, refer to “Phase Adjustment for Nozzle [HLGB-10414-01]”.
O-ring holder
Mask plate
4-CP2.5x5
Setting UPS when exchanging hard disk
Setting UPS when exchanging hard disk
UPS re-setting is required when hard disk is replaced.
[Close HI]
1. Change user level to SERVICE.
Click Key mark on the left side
shoulder to show USER LEVEL
setting screen.
2. Click SERVICE radio button to fill
pass word field.
Enter pass word to click Set button.
3. X appears on the right shoulder of
the screen.
Click the X mark to close HI screen.
WKGB-10103-02
Setting UPS when exchanging
hard disk
1/14
Setting UPS when exchanging hard disk
WKGB-10103-02
Setting UPS when exchanging
hard disk
2/14
[Device driver re-installation]
This work should
be done on the machine
front and rear separately.
1. Open Control Panel window.
Open Control Panel window from
Windows Start Menu.
2. Make double click on the System to
show System Properties window.