4OM-1345-009_w.pdf - 第104页
1-48 AKHEMT -ID 4.2 Lubrication for Ball Screw Splines (1) Zero the conveyors and the heads. (2) Move the backup base upward. (3) T urn off the power to the machine. (4) Open the cover . (5) T ake out the backup plate. N…
1-47
AKHEMT-ID
Ultrasonic Cleaning Method
•
Set the nozzles in a nozzle cleaning jig as one shown in the fi gure below
and dip the jig low in the ultrasonic cleaner with water. Keep it in the jig
for approximately 15 minutes for the cleaning.
Note
The nozzle cleaning jig must be prepared on the customer side.
•
After washing with the ultrasonic cleaner, blow air to the nozzles.
When the nozzles are not dry enough, wipe them with a rag.
Notice
When a nozzle is set in the jig, pay attention to the orientation of the
nozzle.
(159)
12
12
12
12
12
12
12
12
12
12
12
13.5
15
10
15
15
(65)
10
15
13.5
10
Material: Duracon (POM)
Unit: mm
Fig. 4A44 Nozzle Cleaning Jig (Example)
0605-002
4.1 Cleaning of Vacuum Nozzles
1-48
AKHEMT-ID
4.2 Lubrication for Ball Screw Splines
(1) Zero the conveyors and the heads.
(2) Move the backup base upward.
(3) Turn off the power to the machine.
(4) Open the cover.
(5) Take out the backup plate.
Notice
If the backup plate collides with a conveyor, etc., the machine will
break down.
Be sure to handle the backup plate carefully.
Backup Plate
Fig. 4A44-1
(6) Apply grease to the ball screw splines of the backup base through
the holes on the backup base with a syringe.
Note
Use No. 19 (brown) nozzle.
Inject grease into
these holes.
Inject grease into
these holes.
Fig. 4A45
0602-001
4.2 Lubrication for Ball Screw Splines
1-49
AKHEMT-ID
(7) Attach the backup plate to the backup base board so that the
chamfered side of the backup plate can be seated toward the central
side of the machine.
Notice
(a) Attach the backup plate so that the chamfered side can be
seated toward the central side of the machine.
If the plate is not attached correctly, the machine will break
down.
(b) Do not allow any foreign substance to be trapped between
the backup base board and the backup plate. Otherwise, the
machine will break down.
(c) After the backup plate has been attached, confi rm that it is
seated fi rmly without any play, is not tilted, and is directed
correctly.
Set up the backup plate so that the chamfered
side can be seated toward the right side of
the machine.
Chamfered Side
Fig. 4A46
0602-001
4.2 Lubrication for Ball Screw Splines