4OM-1345-009_w.pdf - 第77页
1-22 AKHEMT -ID 3.3.3 Component Recognition Camera Section Notice Be sure to use a suction force such as a vacuum cleaner for the cleaning. Do not blow air to any cleaning section with an air gun. Hood (for BGA component…
1-21
AKHEMT-ID
3.3.2 Vacuum System
Vacuum Pressure (1 Place)
Every Day Inspection
Required Time: 1 minute
Check the vacuum pressure visually.
Vacuum Valve Fully Closed:
Min. -93 kPa (Min. 70 cmHg) or more
Running:
Min. -60 kPa (Min. 45 cmHg) or more
When the vacuum pressure is insufficient,
air may be leaking from the vacuum line or
the vacuum pump may have broken down.
Fig. 4A12
C
Setscrews
Filter
Every 3 Months Cleaning
(1) Remove four setscrews fastening the cover located at the lower area
of the front side of the machine and detach the cover.
(2) Rotate the filter case in Arrow Direction C to detach and then take out
the filter.
(3) Blow air to the filter for cleaning.
When the vacuum pressure has dropped during the operation, replace
the filter with a new one.
(4) Attach the cover and tighten the setscrews.
If a clearance is left between the main machine and the
cover, the tape will pop out from the clearance during the
operaton, causing the machine to breakdown or generate
an error.
Filter Case
Setscrews
Notice
Required Time: 5 minutes
Fig. 4A13
0602-001
3.3 Inspection, Cleaning, and Lubrication Spots
1-22
AKHEMT-ID
3.3.3 Component Recognition Camera Section
Notice
Be sure to use a suction force such as a vacuum cleaner for the
cleaning.
Do not blow air to any cleaning section with an air gun.
Hood
(for BGA components)
Component Recognition Camera
Every Day Cleaning
Required Time: 4 minutes
Remove the components that have fallen
with a pair of vacuum tweezers and wipe
off dust with a lens cleaning cloth.
Fig. 4A14
CAUTION
Be sure to wear gloves during cleaning. Otherwise, you may cut
your hands on the edges of the lighting hood.
Note
G-S047-01 Adhesive Cleaner (Part No: 630 133 0679) is also available
as an option.
Adhesive Cleaner
Fig. 4A14-1
0712-003
3.3 Inspection, Cleaning, and Lubrication Spots
1-23
AKHEMT-ID
CAUTION
CAUTION
Before removing the accumulated components from the box, be
sure to connect a grounding cable (used to make a connection
to ground) to your body.
Otherwise, some component may be damaged by static
electricity.
Hanenaito (Vibration Proof Rubber)
Every Day Cleaning
Required Time: 1 minute
Take out Hanenaito from the component
storage box and clean it with a vacuum
cleaner.
Component Storage Box
Every Day Cleaning
Required Time: 1 minute
Remove components collected in the box.
Fig. 4A15
0605-002
3.3 Inspection, Cleaning, and Lubrication Spots