4OM-1345-009_w.pdf - 第111页

1-55 AKHEMT -ID (9) Put the ﬂ at ring replacement jig on the roller on the oscillating side (outside of the machine). Push only the ﬂ at ring downward by hand and insert it into the groove of the roller . Flat Ring Fig. …

1-54

AKHEMT-ID

(6) Use the inner holes of the cut unit ﬁ xing jig with the tape clamp being

closed and attach the jig with the bent portion being directed upward.

Fig. 4A52

WARNING

Pay close attention to the cutter blade during the maintenance

work.

•

Lack of attention will result in a hand injury, etc.

•

Be sure to attach the ﬁ xing jig to the cut unit during the

maintenance work for safety purposes.

(7) Cut the used ﬂ at ring with a cutter on market and detach it.

(8) Attach the ﬂ at ring to the ﬂ at ring replacement jig.

Fig. 4A53

0602-001

4.4 Procedure of Flat Ring Replacement

1-55

AKHEMT-ID

(9) Put the ﬂ at ring replacement jig on the roller on the oscillating side

(outside of the machine).

Push only the ﬂ at ring downward by hand and insert it into the groove

of the roller.

Flat Ring

Fig. 4A54

(10) Pay attention to the cutter blade and detach the ﬂ at ring replacement

jig.

(11) Attach the tape guide and the transparent cover.

0602-001

4.4 Procedure of Flat Ring Replacement

1-56

AKHEMT-ID

4.5 Cleaning of Linear Measure Sensor

Periodically perform cleaning of the linear measure sensor to maintain

reliable and stable measurement of component thickness.

•

Clean the sensor every day.

•

Change cleaning frequency according to varying frequency of use and

environmental conditions.

Conic Cap

Linear Measure Sensor

(Light Emitter)

Linear Measure Sensor (Light Receiver)

Surface of Conic

Reflector

Horizontal Direction

Linear Measure Sensor (Light Emitter)

Fig. 4A55

•

While you are cleaning the light emitter, the surface of the conic reﬂ ector

must be cleaned softly and horizontally.

Notice

Cleaning it vertically may damage the conic cap.

When the conic cap is damaged, the component recognition might

not be made correctly.

CAUTION

The light emitter of the linear measure sensor is made of glass.

If the light emitter happens to be damaged, be sure to suck up

the fragments with a vacuum cleaner, etc.

Do not collect the fragments with your bare hands to protect

your hands from injuries.

0609-002

4.5 Cleaning of Linear Measure Sensor