OM-1743-005w.pdf - 第115页
7.5.2 How to Apply Grease to the Sprocket Driving Gear Unit Note (a) Do not remove the timing belt. (b) Do not apply grease onto the timing belt. Procedure (1) Opening the Left Side Cover (Refer to the item for the cover…
1209-001
7.5.1.8 Right Side Cover Attachment Procedure
Procedure
(1) Hold the upper side of the Right Side Cover and slide it in the arrow
direction to attach.
Insert the claw section on the Right Side Cover into the slit with the sequence
of 1, 2, 3 and 4 shown in the gure below and slide the cover while pressing
it from above.
Sliding Direction
Step 2
Step 3
Step 4
Step 1
Fig. G27
Note
When the cover is attached, take care not to catch any cable.
(2) Fasten the cover set screws to x the Right Side Cover.
Cover Set Screws
Fig. G28
7.5 Maintenance Method
OM-1743
7-20
7.5.2 How to Apply Grease to the Sprocket Driving Gear Unit
Note
(a) Do not remove the timing belt.
(b) Do not apply grease onto the timing belt.
Procedure
(1) Opening the Left Side Cover (Refer to the item for the cover opening for the
procedure).
Open the Left Cover to expose the sprocket unit.
Sprocket Unit
Right
Timing
Pulley
Left
Timing
Pulley
Oiling Cap
Fig. G29
(2) Aligning the left sprocket position
Align the blue marked position on the sprocket rim with the lowermost
position.
Tun the left timing pulley so that the oiling cap locates the lowermost of the
left sprocket.
Right
Sprocket
Left
Sprocket
Oiling Cap
Fig. G30A
1901-005
7.5 Maintenance Method
OM-1743
7-21
(3) Removing the oiling cap
Remove the oiling cap to open the oiling port.
Because the cap has been screwed in to x, turn it with a slotted screwdriver
to remove.
Oiling Port
Fig. G31
(4) Aligning the right sprocket position
Turn the right timing pulley so that the oil section of right sprocket locates
the same position as the oil section of left sprocket while seeing the oil
section of left sprocket.
If it is difcult to see the oil section, use a light or insert the lubricating jig to
check the oil section of right sprocket.
Oiling Section on the Right Sprocket Driving Gear.
(At the back of the screw hole)
Oiling Section on the Left Sprocket Driving Gear.
Fig. G32 Oiling Port Enlarged View
1901-005
7.5 Maintenance Method
OM-1743
7-22