OM-1743-005w.pdf - 第66页
4.2.6 Minimum Pitch Returning Operation When returning operation is to be performed, loosen the cover tape tension in advance. In the case that the cover tape tension is not loosened, the tension is loosened automaticall…
4.2.5 Set Pitch Returning Operation
When returning operation is to be performed, loosen the cover tape tension in
advance.
In the case that the cover tape tension is not loosened, the tension is loosened
automatically when the returning operation is performed. However, when the
returning operation is continued several times repeatedly, the tape might be
damaged. Pay attention to the tape.
Procedure
(1) Press the button to select the lane.
(2) Press the
button and at the same time, press the button.
(3) Within 2 seconds, release your nger from the
button only and keep
pressing the button.
(4) Using the ON/OFF operation of the
button, execute the 1 pitch feed
operation.
Repeating the ON/OFF operation of the
button can continue the feed
operation.
Note
When the continuous returning operation is to be performed, make sure
that the cover tape tension has been loosened.
(5) Release your nger from the button.
(6) Press the
button to take up the cover tape and set it to the specied
tension before ending the operation.
1209-001
4.2 Operation of Operation Panel
OM-1743
4-5
4.2.6 Minimum Pitch Returning Operation
When returning operation is to be performed, loosen the cover tape tension in
advance.
In the case that the cover tape tension is not loosened, the tension is loosened
automatically when the returning operation is performed. However, when the
returning operation is continued several times repeatedly, the tape might be
damaged. Pay attention to the tape.
Note
In the case of the minimum pitch return, the tape is not fed in the rst start
operation. This is because servo-ON processing is performed for the tape feed
servo-motor to return to the home position from any other position.
In this case, repeat the operation within 1 second.
The servo ON condition is continued for 1 second.
Procedure
(1) Press the button to select the lane.
(2) Press the
button and at the same time, press the button.
(3) Within 2 seconds, release your nger from the
button only and keep
pressing the
button.
(4) Using the ON/OF operation of the
button, execute the minimum pitch
returning operation.
Repeating the ON/OFF operation of the button can continue the
minimum pitch returning operation.
(5) Release your nger from the
button.
(6) Press the
button to take up the cover tape and set it to the specied
tension before ending the operation.
1209-001
4.2 Operation of Operation Panel
OM-1743
4-6
4.2.7 Cover Tape Take-up Operation
Procedure
(1) Press the button to select the lane.
(Only for 8 mm width Tape Feeder)
(2) Press the
button.
While the button is being pressed, the cover tape take-up motor continues to
be driven.
However, if the cover tape tension detection sensor on the cover tape take-up
section is activated, then the motor is automatically stopped.
Also, if the
button is pressed while the sensor is activated, then the cover
tape take-up motor is not activated.
Cover Tape Take-up Motor
Cover Tape
Tension Lever
Cover Tape Tension Detection Sensor
Cover Tape
Cover Tape
Slack Cover Tape
(Tension Detection Sensor OFF)
Tensed Cover Tape
(Tension Detection Sensor ON)
Fig. D2
1209-001
4.2 Operation of Operation Panel
OM-1743
4-7