OM-1743-005w.pdf - 第43页

2.3 Detachment of Paper or Embossed T ape Procedure (1) T ake out the cover tape from the cover tape housing section. Cover T ape Housing Section Fig. B17 Reference Refer to "2.4 Remove the Cover T ape" for det…

100%1 / 151
1209-001
2.2.1 Check and Points after Cover Tape Tension Loosening
Check the following items so that the cover tape is not loosened too much.
•
Tension Lever Position Check
After loosening the cover tape tension, make sure that the tension lever angle is
horizontal.
After Tension
Loosening Work
Status where the cover tape is tensed
Status where the cover tape tension is loosened
Fig.B15
•
Cover Tape Status Check on the Suppressor Upper Side
Make sure that the cover tape does not rise over the suppressor upper side due
to being too loose.
Notice
In the case that the tape feeder is attached to the machine body with the
cover tape too loose, the cover tape might contact the head and cause
an operation error.
OK Status :
The cover tape does not rise after
the tension is loosened.
NG Status :
The cover tape rises because the
tension has been loosened too much.
Fig. B16
2.2 Cover Tape Tension Loosening Procedure
OM-1743
2-12
2.3 Detachment of Paper or Embossed Tape
Procedure
(1) Take out the cover tape from the cover tape housing section.
Cover Tape Housing Section
Fig. B17
Reference
Refer to "2.4 Remove the Cover Tape" for details.
(2) Press down the cover tape take-up release lever and remove the cover tape.
Cover Tape
Cover Tape Take-up Release Lever
Fig. B18
(3) While gently pressing the end of the suppressor with your nger, press the
lower side of the end hook to lift the suppressor.
1209-001
2.3 Detachment of Paper or Embossed Tape
OM-1743
2-13
(4) Lift the suppressor and remove the cover tape in the horizontal direction
from the peeling section.
Notice
Do not remove the cover tape forcibly pulling it.
If the cover tape is deformed and passes through the peeling
section, then the peeling section might become deformed, causing
a pick-up error.
4
2
Cover Tape
Suppressor
Fig. B19
(5) Turn the tape reel and take-up the tape on the tape reel.
Notice
If the tape is taken up while the cover tape is left on the peeling
section, the peeling section might become deformed, causing a
pick-up error.
1305-003
2.3 Detachment of Paper or Embossed Tape
OM-1743
2-14