OM-1743-005w.pdf - 第39页

(13) Press down the cover tape take-up release lever , insert the end of the cover tape into the cover tape housing section, and reset the cover tape take-up release lever . Notice • It should be conrmed that there is …

(12) Use scissors to cut the tape, so that the excess tape section is 5 to 10 mm.

Notice

Use scissors which would not cut ngers, and cut the tape one by

one.

Tape

5 to 10 mm

Fig. B11

Notice

When the tape is cut, do not fold the end section.

The tape might not be cut correctly by using the cutter attached to

the machine (SIGMA-G4/G5).

Folding

Fig. B12

1209-001

2.1 Attachment of Paper or Embossed Tape

OM-1743

2-8

(13) Press down the cover tape take-up release lever, insert the end of the cover

tape into the cover tape housing section, and reset the cover tape take-up

release lever.

Notice

•

It should be conrmed that there is not anything sticking, or any

twist or knot of the cover tape.

•

Take care so that your nger is not caught by the take-up gear.

Cover Tape Housing Section

Cover Tape Take-up Release Lever

Cover Tape

Hold the end of the cover tape between fingers

as shown in the figure and insert it into the cover tape

housing section.

Take-Up Gear Section

Fig. B13

(14) Select the lane to be used using the lane selection button on the operation

panel and press the take-up button to send the cover tape to the cover tape

housing section.

Press the take-up button, continuously, until the take-up gear is stopped

automatically.

Reference

Refer to "4. Operation Panel" for operation panel.

1209-001

2.1 Attachment of Paper or Embossed Tape

OM-1743

2-9

•

Cleaning of Suppressor Fulcrum Point

Chip components which scatter during the tape cassette setup operation and

enter inside the suppressor from the gap between the suppressor and the chute,

might be accumulated at the suppressor fulcrum point (between the chute under

the suppressor and the body).

Accumulated chip components around this area hinder the suppressor opening

or closing operation, so clean this area diligently.

Reference

Refer to "7.4.4 Component Discharging Section" for the details of

maintenance.

1209-001

2.1 Attachment of Paper or Embossed Tape

OM-1743

2-10