OM-1743-005w.pdf - 第46页

(2) Cut the drawn cover tape with the cutter in the tape feeder . Cutter Fig. B21 1209-001 2.4 Remove the Cover T ape OM-1743 2-16

2.4 Remove the Cover Tape

The amount of housing in the cover tape housing section is as much as about one

and half small reels. Whenever the tape is to be replaced, or spliced, remove the

cover tape from the cover tape housing section.

Notice

When the cover tape housing section is lled with the cover tape and no

more tape can be pressed in, the roll-in gear will be locked, which might

cause malfunction of or damage to the tape feeder.

Procedure

(1) Open the cover tape outlet cover and pull the cover tape from the cover tape

housing section.

Cover Tape

Cover Tape Outlet Cover

[1] Open the cover tape outlet cover.

[2] Pull the cover tape in the direction of the arrow.[2] Pull the cover tape in the direction of the arrow.

[1] Open the cover tape outlet cover.

Fig. B20

1209-001

2.4 Remove the Cover Tape

OM-1743

2-15

(2) Cut the drawn cover tape with the cutter in the tape feeder.

Cutter

Fig. B21

1209-001

2.4 Remove the Cover Tape

OM-1743

2-16

2.5 Joint Detection Unit

Set the tape after inserting the tape into the guide of the joint detection unit.

Procedure

(1) Bend the cover tape at the end of the tape and pass the tape according to the

tape guide from under the joint detection unit.

Pass the tape from

the lower side

Tape guide

Bend the cover tape at the end tape

Fig. B22

1209-001

2.5 Joint Detection Unit

OM-1743

2-17