西门子SIPLACE S-27 HM用户手册.pdf - 第124页

5 Operator, Line engineer, Service engineer User Manual SIPLACE S -27 HM 5.9 Docking and undoc king the component trolley Software version SR. 503.xx07/2003 US Edition 124 5.9 Docking and undo cking the componen t trolle…

User Manual SIPLACE S-27 HM 5 Operator, Line engineer, Service engineer

Software version SR.503.xx 07/2003 US Edition 5.8 Refilling components

123

5.8 Refilling components

The online help contains information on refilling components with and without barcodes.

Æ With tape feeders, make sure that you always splice on a new tape early enough so that the

feeders do not run out of components.

Æ However, do not splice the tapes too early because if you wind the tape onto the new reel after

splicing the end of the old tape, the reel with the new tape may be over-filled. The tape could

then slip off the reel and become tangled. Under certain circumstances, this could cause pick-

up errors and prolonged down times.

Æ Always insert spindles when using tape reels of 7" and larger (see Fig. 5.4 - 3) and make sure

that the dividing plates are inserted correctly (see Fig. 5.4 - 3

5 Operator, Line engineer, Service engineer User Manual SIPLACE S-27 HM

5.9 Docking and undocking the component trolley Software version SR.503.xx07/2003 US Edition

124

5.9 Docking and undocking the component trolley

5.9.1 Safety instructions on docking and undocking the component trolley

WARNING 5

Æ Never reach into the gap between the component trolley and the placement system frame

(item 1).

Æ Always check that the component trolley is docked on the placement system before connecting

or disconnecting the power cable for the component trolley at the socket on the placement sys-

tem (item 2).

Æ NEVER connect the connecting cable for the component trolley to the socket on the placement

system and then operate the component trolley outside the machine via the compressed air

control unit (item 3).

Fig. 5.9 - 1 Safety instructions on the component trolley

User Manual SIPLACE S-27 HM 5 Operator, Line engineer, Service engineer

Software version SR.503.xx 07/2003 US Edition 5.9 Docking and undocking the component trolley

125

Fig. 5.9 - 2 Docking or undocking the component trolley

(1) Communication interface connector

(2) Power supply connector for the component trolley

(3) Compressed air connection

(4) Component table bed

(5) Button for raising and lowering the component table bed

(6) Actuating tube