AltaPail II Bulk Melters Product Manual.pdf - 第144页

Maintenanc e 8-7 Part 1121836_03 E 11/2014 Nordson Corporation Fan and A ir Filter Depending on dust accumulation, the air filters in the fan and for the air outlet must be cleaned (knocked out) or replac ed. Refer to se…

Maintenance

8-6

Part 1121836_03

E 11/2014 Nordson Corporation

Purging with Cleaning Agent

Place a container of cleaning agent in the bulk melter to purge. Then feed the

cleaning agent until it comes out free of material residue.

CAUTION: Use only a cleaning agent recommended by the hot melt

material manufacturer. Observe the Material Safety Data Sheet for the

cleaning agent.

Before starting production again, flush out residue of the cleaning agent

using the new material.

NOTE: Properly dispose of cleaning agent according to local regulations.

Cleaning Melting Plate

The melting plate is standardly release-coated. This makes it easy to clean.

Cooled material can usually be pulled off of the melting plate; if necessary,

first heat to approx. 60 ° C / 140 ° F.

CAUTION: Do not use hard or metallic tools to clean. Do not use wire

brushes! This could damage the release coating. Use only soft aids

(wooden or PTFE spatula or soft brush).

Maintenance

8-7

Part 1121836_03

E 11/2014 Nordson Corporation

Fan and Air Filter

Depending on dust accumulation, the air filters in the fan and for the air outlet

must be cleaned (knocked out) or replaced.

Refer to separate document Parts for filter order numbers.

Figure 8-1

1 Fan 2 Air filter, air outlet

Maintenance

8-8

Part 1121836_03

E 11/2014 Nordson Corporation

Motor / Gear Box

Change lubricant

Observe when changing lubricant:

Drain lubricant when warm

Use only the stated lubricant or one that has proven to be equivalent.

Using any other lubricant can result in premature wear and/or damage to

the gear box

Properly dispose of the old lubricant according to local regulations.

Remove gear box from the motor to change lubricant. Wash out casing with

suitable cleaning agent and remove lubricant residue.

Lubricant Changing Interval

When lubricant temperature is below 100° C / 212° F:

Every 15000 hours of operation or at least every 2 to 3 years.

Capacity

The lubricant quantity is indicated on the ID plate.

NOTE: Never mix different types of lubricants.

Lubricant Selection

Lubricant manufacturer Mineral oil CLP 220

AGIP Blasia 220

ARAL Degol BMB 220 or Degol BG 220

BP Energol GR-XP 220

DEA Falcon CLP 220

ESSO Spartan EP 220 or GP 90

KLÜBER Klüberoil GEM 1-220

OPTIMOL Optigear 220

SHELL Omala Oil 220

TEXACO Geartex EP-A SAE 85 W-90