AltaPail II Bulk Melters Product Manual.pdf - 第32页
Installation 3-1 Part 1121836_03 E 11/2014 Nordson Corporation Section 3 Installation WARNING! Allow only qual ified personnel to p erform the following ta sks. Follow the safety instructions in th is document and all ot…
Introduction
2-8
Part 1121836_03
E 11/2014 Nordson Corporation
Modes
AltaPail bulk melters operate in the following modes:
Normal Mode (Auto Scan)
When the bulk melter is first switched on, it is in normal mode. In normal
mode the bulk melter checks the current temperature of the platen, the hoses
and the applicators to verify that they are within the set temperature ranges.
Standby
The temperatures of the platen, the hoses and the applicators are lowered
from their operating temperature (hereafter referred to as set point
temperature) by a set number of degrees.
Fault
The bulk melter alerts the user when a fault occurs, e.g. a sensor fault (RTD)
or a temperature that is not within the permitted range.
Installation
3-1
Part 1121836_03
E 11/2014 Nordson Corporation
Section 3
Installation
WARNING! Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Installation Personnel's Experience
The instructions contained in this section are intended for personnel with
experience/authorization in the following fields:
S
Application methods with hot melt adhesive or similar materials
S
Industrial electrical wiring of power and control lines
S
Industrial mechanical installation
S
General knowledge of process control.
Transport
S
Refer to page 12-5, Dimensions and Weights for weight. Use only
suitable transport devices (lift truck or forklift). Do not lift with a crane.
S
If possible, use the pallet on which the bulk melter was delivered, and
fasten the bulk melter to the pallet.
S
Protect from damage, moisture and dust with suitable packing material.
S
Avoid jolts and vibrations.
Storage
Do not store the bulk melter outside! Protect from humidity, dust and
extreme temperature fluctuations (formation of condensation).
Installation
3-2
Part 1121836_03
E 11/2014 Nordson Corporation
Hardware Installation Tasks
S
Verify that the required installation conditions and utilities exist.
S
Unpack and inspect the melter.
S
Mount the melter on the parent machine or support structure.
S
Configure the electrical service.
S
Connect hot melt hoses and applicators and/or handguns.
S
Connect a compressed air supply.
S
(Optional) Install inputs and outputs.
S
Set up the melter for gear-to-line operation.
S
(Optional) Connect an applicator driver, pattern controller, or timer.