AltaPail II Bulk Melters Product Manual.pdf - 第24页

Introduction 2-1 Part 1121836_03 E 11/2014 Nordson Corporation Section 2 Introduction Intended Use Bulk melters of the serie s AltaPail II - herea fter also re ferred to as me lter - may only be used to melt and fee d su…

100%1 / 230
Safety
1-12
E 11/2014 Nordson Corporation
Safe_PPA1011LUE_EN
Table 1-2 Safety Labels and Tags
Position P/N Description
1 290083 WARNING: Risk of electrical shock. Failure to observe may result
in personal injury, death, or equipment damage.
2 290082 WARNING: Hot surface. Failure to observe can cause burns.
3 421460 WARNING: Risk of pinching parts of the body between platen
and container. Ensure that, during operation, no one else is near
the system.
4, and 5 1059866 TAGS, SHEET OF, VERSA/DURABLUE LG, CE LANG
6 10000291 TAG,UNIT STAMPING,ALTAPAIL II
7 7140255 SIGN "MAX. 8 BAR" SELF ADHESIVE
NOTE: All the safety labels and tags can't be wiped by organic
solvents(alcohol, acetone,etc.)
Introduction
2-1
Part 1121836_03
E 11/2014 Nordson Corporation
Section 2
Introduction
Intended Use
Bulk melters of the series AltaPail II - hereafter also referred to as melter -
may only be used to melt and feed suitable materials. When in doubt, seek
permission from Nordson.
Any other use is considered to be unintended. Nordson will not be liable for
personal injury or property damage resulting from unintended use.
Intended use includes the observance of Nordson safety instructions.
Nordson recommends obtaining detailed information on the materials to be
used.
Unintended Use - Examples -
The bulk melters may not be used under the following conditions:
S
In defective condition
S
With electrical cabinet door open
S
In a potentially explosive atmosphere
S
With unsuitable operating/processing materials
S
When the values stated under Technical Data are not complied with.
The systems may not be used to process the following materials:
S
Explosive and flammable materials
S
Erosive and corrosive materials
S
Food products.
Do not use the platen
S
As a press
S
To lift loads
S
To heat objects.
Area of Use
The bulk melter is designed for use in industrial areas.
When using in industrial areas and in small businesses, the system may
cause interference in other electrical units, e.g. radios.
Introduction
2-2
Part 1121836_03
E 11/2014 Nordson Corporation
Residual Risks
In the design of the melter, every measure was taken to protect personnel
from potential danger. However, some residual risks can not be avoided.
Personnel should be aware of the following:
S
Risk of burns from hot material
S
Risk of burns from hot bulk melter components
S
Risk of burns when conducting maintenance and repair work for which
the system must be heated up
S
Risk of burns when attaching and removing heated hoses
S
Material fumes can be hazardous. Avoid inhalation. If necessary, exhaust
material vapors and/or provide sufficient ventilation of the location of the
bulk melter (Refer to page 3-3, Exhausting Material Vapors)
S
Risk of pinching parts of the body between platen and container. Ensure
that, during operation, no one else is near the system
S
The safety valve may malfunction due to hardened or charred material.
ID Plate
Electrical connection
Operating voltage
Operating voltage frequency
Rated current
System designation
Serial number