00197042-04_SM_X-Serie-S_Customer_EN.pdf - 第144页
5 Pneumatic System 5.10 Replacing the electronic ballast for the ELMO blower 144 Service Manual SIPLACE X-Serie S 06/2019
5 Pneumatic System
5.10 Replacing the electronic ballast for the ELMO blower
Service Manual SIPLACE X-Serie S 06/2019 143
5.10 Replacing the electronic ballast for the ELMO blower
Parts, equipment and tools
●
Electronic ballast for ELMO blower [03006517-xx]
Overview
Fig.178: ELMO blower
1. Elmo blower electronics
2. Elmo blower
3. Cooling air filter
The ELMO blower is located at location 3,
behind the side cover.
Removal
► Removal and installation of the Elmo blower electronics is the same as that for the Elmo
blower itself. For more information, read section 5.9 "Replacing the side channel compressor
Elmo blower (location 3)" [}142].
5 Pneumatic System
5.10 Replacing the electronic ballast for the ELMO blower
144 Service Manual SIPLACE X-Serie S 06/2019
6 Gantries
6.1 Gantries
Service Manual SIPLACE X-Serie S 06/2019 145
6 Gantries
DANGER
Observe User Manual
► Please observe the safety instructions in the user manual for all work!
CAUTION
Use the correct blanking plugs
► Only use blanking plugs in the machine which match the manufacturer's compressed
air connection. A tight fit cannot be guaranteed for other blanking plugs.
► We recommend the use of blanking plugs made by Festo.
6.1 Gantries
Fig.179: Overview of gantry
1. Head interface and Vision board
The Vision board is fitted on the head
interface.
2. Y axis trailing cable
3. Y axis
4. X axis
5. X axis trailing cable
6. Y drive (primary)
7. Y scale
6.2 Replacing the Gantry
DANGER
Danger of crushing
The attraction force of the magnets is 400Nm.
CAUTION
Do not loosen or remove the screws
The loosening and removing of the fastening screws leads to tension. This has a negative
effect on the product life.
NOTICE
SIPLACE Service
This task may only be performed by SIPLACE service technicians.