c900773.R02_EN.pdf - 第53页

3 Mechanical Section 3-13 Nozzle ID Stickers Labeling a Nozzle ID Sticker to a Nozzle ACTION: ① Use industrial alcohol and comple tely remove grease, oil, and water content from the surface of the nozzle flange where a n…

3 Mechanical Section

3-12

ACTION:

① Insert the filter with tweezers and adjust the position of the filter using the O-ring insertion jig.

Correct Incorrect

② Set the O-ring at the tip of the nozzle and slowly push it all the way to the bottom by using the O-ring

insertion jig.

③ Slowly pull out the insertion jig.

④ Check to make sure that the filter and the O-ring are set in place correctly.

3 Mechanical Section

3-13

Nozzle ID Stickers

Labeling a Nozzle ID Sticker to a Nozzle

ACTION:

① Use industrial alcohol and completely remove grease, oil, and water content from the surface of

the nozzle flange where a nozzle ID sticker is to be labeled.

② Pull out the shaft of the nozzle sticker tool approx. 3mm from the ring.

③ Use tweezers and peel off the sticker from the paper.

④ Place the sticker with its adhesive side up, and then put it in the jig (make sure that the D-cut on

the sticker is aligned with that on the ring). (The sticker must be angled so that the nozzle ID

number is oriented as illustrated below.) Do not touch the adhesive surface of the sticker with

fingers.

⑤ Push the nozzle into the shaft of the nozzle ID sticker tool. Make sure that the nozzle’s notch is

aligned with the positioning slot on the ring.

⑥ While pressing the nozzle flange, push the shaft into the ring so that the sticker is affixed onto the

flange.

⑦ Check to make sure that the sticker touches the bottom of the ring.

NOTE: When the shaft is pulled out of the ring too much, it may come off. When it comes off, align the shaft’s slot

with the ring’s positioning pin and then insert the shaft into the ring slowly.

Part Name

Part No. Remark

ID SEAL TOOL, ASSY. LC1-M8903-00X Nozzle ID sticker tool

Nozzle ID sticker tool

D-cut

Shaft

Positioning pin

Ring

Positioning slot

Nozzle ID sticker

Nozzle

Notch

ID No. (P***)

3mm

3 Mechanical Section

3-14

Cleaning Nozzle ID Stickers

Dirt on nozzle ID stickers may cause vision recognition failure. Regularly clean the nozzle ID stickers.

ACTION:

① Clean the sticker with cotton swab soaked with alcohol.

② Wipe off the remaining alcohol from the sticker surface with dry cotton swab.

NOTE: Particularly the nozzle ID stickers tend to easily get dirty. When a nozzle ID sticker becomes too dirty to be

cleaned, replace it with a new one.

For the part number of the nozzle ID sticker, refer to “5. Materials”.

NOTE: The nozzle ID stickers are easily peeled off when they become wet. Be sure to dry them with cotton swab

whenever they become wet.