c900773.R02_EN.pdf - 第58页
3 Mechanical Section 3-18 Lubrication Lubrication Points Lubricate the poin ts listed below with cotton swab soaked with sp ecified lubricant. UNIT LUBRICATION POINT LUBRICANT FREQ. Ball Screw of X-axis Grease Every two …
3 Mechanical Section
3-17
Cleaning Teach Camera
The lens of teach camera faces downward, and usually dust and dirt hardly attach to it under the normal
operational condition. However, if it becomes dirty, blow the air by using an air blower brush from the
bottom of the teach camera and remove the dust and dirt.
Cleaning Lens Filter
When components or obstacles fall onto the lens filter, remove them with a blower brush or tweezers.
When grease sticks on the filter, use camera lens cleaner and lens cleaning tissue and remove it.
If condensation occurs inside the protective filter, remove the protective filter and wipe off the moisture
with lens cleaning tissue.
3 Mechanical Section
3-18
Lubrication
Lubrication Points
Lubricate the points listed below with cotton swab soaked with specified lubricant.
UNIT LUBRICATION POINT LUBRICANT FREQ.
Ball Screw of X-axis Grease Every two weeks
Linear Guide of X-axis (Upper and Lower) Grease Every two weeks
Ball Screw of Y-axis (Right and Left) Grease Every two weeks
Linear Guide of Y-axis (Right and Left) Grease Every two weeks
Feeder Bank Plates Grease Every two weeks
Conveyor Width Adjusting Screw Grease Monthly
M10/M20 Conveyor Guide Shaft Grease Monthly
Conveyor PCB Clamp Plate Shaft Grease Monthly
Ball Screw of Z-axis Grease Every two weeks
Spline Shaft of Z-axis Grease Every two weeks
Linear Way of Z-axis Grease Every two weeks
Nozzle Holder Silicone Grease Monthly
Nozzle Silicone Grease Weekly
NOTE: Do not apply excessive oil or grease. They may be scattered when the mounter is in motion.
3 Mechanical Section
3-19
■ Lubrication Points on X/Y-axis, Conveyor, Feeder bank plates
X and Y axis Ball Screw are covered by plates (Cover Plate). These plates must be removed before
applying grease to X and Y axis Ball Screw and Linear Guides.
X Axis
X Axis Ball Screw
X Axis Linear Guide
Removing the cover plate.
・ Move the head unit all the way to either
left
or right.
・ Unscrew and remove the screws.
Screws are located at both ends of the
cover plate. (see image on the left).
・ Remove the cover plate.
Y axis Linear guide
Y axis ball screw
Conveyor adjusting screw
Conveyor guide shaft
X Axis
X Axis Linear Guide
X Axis Ball Screw
Linear Guide
Ball Screw
Linear Guide
Grease Nipples
・Grease nipples are located at both ends of
upper and lower linear guides.
・Lubricate the ball screw as shown in the
image.