Service Manual HS60.pdf - 第158页
5 Pn eum ati c Cutt er and E mpty-T ape Du ct S er vic e Manu al HS- 60 5.6 C h angi ng of parts 03/2 00 3 US I ss ue 156
Service Manual HS-60 5 Pneumatic Cutter and Empty-Tape Duct
03/2003 US Issue 5.6 Changing of parts
155
Æ Move the changeover table back into the machine and connect it.
DANGER
It is a basic rule that the SITEST program is only to be started by personnel who have been trained
in its use at Siemens AG and are therefore authorized to start it.
When the SITEST program is used, additional, higher risk of an accident exists aside from the
generally higher danger posed by the blades of the cutter.
The cutter and the empty-tape duct have to be completely assembled at all times.
The component changeover table must be moved into the machine and connected correctly.
Never move your hand near the cutter, neither from below nor from above (via the empty-tape
duct), not even to resolve a problem.
When the SITEST program is running, you must always make certain that there is no 2nd person
at the machine, i.e., that no 2nd person can trigger the cutting process or is within the operating
area of the cutter.
Secure the area of the cutters appropriately to keep away other personnel.
The key switch remains locked (= normal mode = position "0").
One-way restrictors are not to be set on the machine. This is only permitted at the factory. 5
Æ Load the SITEST program and actuate the cutting strokes (see Operating Manual "SITEST
Program").
Æ If the nozzle changer was removed:
Use SITEST program to calculate the position of the nozzle changer.
Æ Exit the SITEST program.
Æ Perform a visual check to make certain that all empty-tape ends are correctly guided downward
in the empty-tape duct.
Æ Start the placement sequence.
5
5 Pneumatic Cutter and Empty-Tape Duct Service Manual HS-60
5.6 Changing of parts 03/2003 US Issue
156
Service Manual HS-60 6 Modular PCB conveyor system
03/2003 US Issue 6.1 Introduction
157
6 Modular PCB conveyor system
NOTE
Before dismantling motors, light barriers etc. make sure that the problem is not due to poor con-
nections. For connection details please see Section 6.16 and Section 6.17.
6.1 Introduction
The modular PCB conveyor system is used for both the HS-60 and S-27 HM. This service manual
applies to both machine types. The differences between the two machines are mentioned in the
relevant Sections of this manual.
CAUTION
This service manual contains item numbers for the individual spare parts applicable to both the
HS-60 and the S-27 HM. These are for general reference only. When identifying and ordering
spare parts, you should always use the current version of the spare parts catalog for the machine
concerned.
6.2 Safety instructions
DANGER
For all procedures, please observe the safety instructions described in Chapter 2.
CAUTION
Customers must not undo any screws secured with loctite.