Service Manual HS60.pdf - 第329页
Se rv ic e Ma nu al HS- 6 0 8 M o va bl e C ompo ne nt C han ge ov er Ta ble 03/ 2 003 U S Iss ue 8.2 Pa rt s 327 8.2 Part s Quan tity D esignation Item No . Commen t s - 1 C omp onent chan geover table - SIP LACE HS-50/…
8 Movable Component Changeover Table Service Manual HS-60
8.1 Safety Instructions 03/2003 US Issue
326
DANGER: RISK OF PLACEMENT HEAD CRASH
With all SIPLACE machines, the Y- gantry must always be moved / pushed out of the area
of the component changeover table before changing tables.
This must be accomplished before actuating the compressed air switch to raise the table.
Otherwise there is a risk that the placement head may crash!! 8
WARNING
Parts of your body may be pinched, crushed or severed by the component changeover table if:
- the height is incorrectly set (SMEMA height may only be set by Siemens service engineer:
see Siemens in-house "Retrofit Instructions"),
- a feeder module tips over or falls,
- the component changeover table which has been moved out of the machine tips over
In addition, please comply with the special safety instructions in the relevant section below. 8
CAUTION
Improper actions while lowering or raising the handle of the component changeover table may
lead to a risk of minor injury through being pinched or scraped by the handle.
For this reason, always hold the handle with both hands. 8
Service Manual HS-60 8 Movable Component Changeover Table
03/2003 US Issue 8.2 Parts
327
8.2 Parts
Quantity Designation Item No. Comments
- 1 Component changeover table
- SIPLACE HS-50/60) 00119022-02
- 2 Fixed castor 00337472-01
- 2 Guide castor 00337471-01
- 1 Communications unit for
changeover table 00330037-05
- 1 Cable for component table
(power supply, controls, cord grip) 00350062-01 Total of 1 unit
- 1 Tape container knockout spindle 00343770-01 if needed
- 2 Bowden cable 00342324-02 Total of 2 units
- 1 Bellows cylinder 00373282-01 Siemens Service only
8.3 Tools and equipment
– Set of Allen wrenches
– Sliding caliper (for bowden cable)
– Diagonal cutter (for cable tie)
– 2 Open-end wrenches, width across flats 8 (for bowden cable)
– External power supply for changeover table 00119029-01
– Extension lead for changeover table 00119030-01
8 Movable Component Changeover Table Service Manual HS-60
8.4 Overview of mechanical construction 03/2003 US Issue
328
8.4 Overview of mechanical construction
Fig. 8.4.1 Overview: Layout and exchangeable parts of the movable component changeover table