N7201A654E.pdf - 第13页
1 What if
NPM-TT2 EJM1EE-CT-01T-01
S-12
1 What if
NPM-TT2 EJM1EE-MB-01T-01
Cannot pickup
Feeder error
What if
Pickup motion error
Problem Cause
Check/Solution Reference
1-1-1-1
Pickup condition
error
Supply unit (feeder
or tray) setting
error or defect
Troubleshooting
1-1-1
Intelligent Tape
Feeder
Operating
Instructions
6
Maintenance
4-1-1
Operating
procedure
4-2-4, 4-2-6, 4-2-8
DGS
Programming
Manual
6.5.3
[1.]
Maintenance
5-6
[2]
Contact PFSC.
[3.]
Operating
Procedure
4-1-10
[4,5]
Operating
Procedure
2-4-2, 4-1-10
■For tape feeder
1.Check feeding motion. Adjust if
there is an error.
2.Check for dust or chip
component stuck onto the tape
pusher cover. If so, clean the
cover.
3.Check the peeling motion.
Adjust if there is an error.
1.Wipe off if the feeder attachment
part is contaminated, or remove
if components are jammed.
2.Replace the cutter blade if it is
not sharp enough.
3.Adjust if the tray pickup height Is
not set properly.
4.Fix the position if the tray is
installed incorrectly.
5.Check whether the tray is
properly set on the pallet. Fix it if
necessary
Check whether the pickup
pusher has been properly set.
Adjust if necessary.
Check the vacuum pressure
(appropriate pressure: -87 to
–100kPa). If it is not within the
value, Adjust the pressure.
Check the pickup position setting.
Adjust if necessary.
Check whether too much vacuum
leaks during component pickup.
Adjust if so.
Change to the appropriate pickup
speed.
DGS
Programming
Manual
6.5.3
-
Intelligent Stick
Feeder
Operating
Instructions
3
■For stick feeder
1. Make sure that the stick is
properly installed. Adjust it if
necessary.
2. Check if the vibration
frequency/amplitude volume is
properly adjusted. Adjust them if
necessary.