00197973-10_SM_MaterialTower.pdf - 第49页

0019797 3 - 10 / 02 , 2016 X Axis SIPLACE Mat. Towe r St ora ge Serv ice Manual © ASM 4-9 Loose n the rigid couplin g by loosenin g the upper screw. No w it can be pul led down to conne ct with the motor axi s. Make sure…

X Axis 00197973-10 / 02 , 2016

4-8 © ASM SIPLACE Mat. Tower Storage Service Manual

Step 6

Plug both connection cables.

Step 7

Carefully fit the shaft into the upper coupling.

Securely hold the shaft in one hand and fixate

the rigid coupling by fastening both screws

using a torque key adjusted on 2.5 Newton.

00197973-10 / 02 , 2016 X Axis

SIPLACE Mat. Tower Storage Service Manual © ASM 4-9

Loosen the rigid coupling by loosening the

upper screw. Now it can be pulled down to

connect with the motor axis. Make sure the gap

between the two axes is in the middle of the

coupling so that each part o

f the coupling

clamps one shaft. Fasten both screws using a

torque key adjusted on 2.5 Newton

Step 8

Remove all tools and close the doors of the machine.

Plug in the power connector and switch on the machine.

Initialize the machine by means of the software.

Step 9

In the software, in

System - Storage

Devices/Units

select the appropriate machine in

the table and press

Load.

In tab

Calibration calibrate the X axis and follow

the instructions given by the software.

4.2 X Belt

4.2.1 Introduction

This modification instruction describes how to change the two belts of the X Axis on SIPLACE

Material Tower.

X Axis 00197973-10 / 02 , 2016

4-10 © ASM SIPLACE Mat. Tower Storage Service Manual

Spare part number: 03126677-01

Before starting the maintenance, read the Sa

fety instructions carefully.

After this modification all stacks must be recalibrated. Therefore, SIPLACE Material Tower

must be emptied in advance by means of the software.

4.2.2 Tools, Material and Scheduling

For an effective and efficient maintenance, the following resources have to be provided:

Required Tools / Auxiliary Material / Spare parts

Tools: Allen key nr. 3 and 5

Wrench Nr. 10

Torque key nr. 3 (torque range min-max: 1 N - 10 N)

Metal shears

Belt tension meter (frequency range min-max: 20 Hz - 450 Hz), e.g. Sonic Tension

Meter / Gates Corporation Denver, Colorado

Measuring tape 5m

Auxiliary

Material:

Loctite Threadlocker Blue 242

Spare parts:

03126677

-01, 2x tooth belt 25 ATL5

Length: 1813 mm ± 2 mm