00196504-02_UM_X-Serie_SR70X_EN.pdf - 第230页
Setting up and commissioning User manual SIPLACE X-series Setting up the machine From software version SR.70x.xx 01/2011 EN edition 230 increase the distan ce between the forks so that the machine is lif ted on the side …
User manual SIPLACE X-series Setting up and commissioning
From software version SR.70x.xx 01/2011 EN edition Setting up the machine
229
4.3.4 Presetting the PCB conveyor height
→ Push the forks of the fork-lift under the machine, as shown in Fig. 4.3 - 1.
4
Fig. 4.3 - 1 Contact surfaces - Forks parallel to the direction of PCB transport
(1) Contact surfaces for the forks of the fork-lift
WARNING 4
Please note the following points before you raise the machine in order to avoid irreversible dam-
age to the machine:
– Open the forks just wide enough to position them between the two machine feet (the attach-
ment points are shown in Fig. 4.3 - 1
, page 229). The machine feet are 776 mm apart. NEVER
Setting up and commissioning User manual SIPLACE X-series
Setting up the machine From software version SR.70x.xx 01/2011 EN edition
230
increase the distance between the forks so that the machine is lifted on the side parts of the
machine frame, since this would deform the machine frame.
→ Make sure that the forks are evenly loaded when you lift the machine. A firm support between
the forks and machine will prevent the machine tilting when it is raised. This will also prevent
a one-sided load on the machine feet, which would deform the fixing of the machine feet. We
recommend that a second person watch the machine as it is raised, and make sure that the
machine does not tip to one side when lifted with the fork-lift.
→ With the fork-lift, raise the machine approximately 30 mm. This will avoid any risk of injuring
your feet if you lower the machine feet accidentally.
The machine stands on 6 feet.
– 4 outer machine feet (item 1 in Fig. 4.3 - 3
, page 231)
There are two versions of the outer machine feet: 4
– outer machine foot for the PCB conveyor height of 830 mm, length 369 mm,
item no. 03041008-01 (item 1 in Fig. 4.3 - 2
)
– outer machine foot for the PCB conveyor heights of 900, 930 and 950 mm, length
439 mm, item no. 03000890-02 (item 2 in Fig. 4.3 - 2
).
– 2 middle machine feet (item 2 in Fig. 4.3 - 3
, page 231) with 2 spacers (item 3 and item 4 in
Fig. 4.3 - 3
, page 231) for adjusting the height, if necessary.
4
Fig. 4.3 - 2 Outer machine feet - two versions (dimensions in millimeters)
User manual SIPLACE X-series Setting up and commissioning
From software version SR.70x.xx 01/2011 EN edition Setting up the machine
231
4
Fig. 4.3 - 3 Machine feet
4
(1) Outer machine foot, 4 x, 2 versions (see Fig. 4.3 - 2, page 230)
(2) Middle machine foot, 2 x
(3) Spacer on the side of the power supply unit
(4) Spacer on the side of the pneumatic unit
(5) threaded hole for the middle machine foot
(T) Direction of PCB transport
(P) Pneumatic unit
(S) Power supply unit