00196504-02_UM_X-Serie_SR70X_EN.pdf - 第322页
Tasks on the machine User manual SIPLACE X-series Changing shift From software version SR.70x.xx 01/2011 EN edition 322 5.8.2 Safety instructions for em ptying the waste t ape cont ainer 5 Fig. 5.8 - 1 Safety instruction…
User manual SIPLACE X-series Tasks on the machine
From software version SR.70x.xx 01/2011 EN edition Changing shift
321
5.8 Changing shift
PLEASE NOTE: 5
You will find additional information in the following manuals or data media:
– SIPLACE X-series preventive maintenance manual
– Parts catalog on the product CD
5.8.1 Activities at shift change
→ Splice the tapes early. The feeder modules do not have to be refilled as soon as the new shift
starts. This minimizes extended down times.
→ At the shift change, pass important information on to the next operator. This includes, for in-
stance, changes to the placement program. Also read through the list of the descriptions of
the steps to take in Section 5.12
, page 340.
→ Carry out a set-up check.
Make sure that the feeder modules are equipped with the correct components, that they are
at the correct locations in the component trolley and that the conveyor increment is set cor-
rectly.
→ Hand over the line in the same state that you would want to find it in when starting your shift.
This means that:
– The rejection containers are empty.
– The waste tape containers are empty. Follow the safety instructions given in Section
5.8.2
, page 322.
– The feeder areas have been carefully cleaned with a vacuum cleaner.
Tasks on the machine User manual SIPLACE X-series
Changing shift From software version SR.70x.xx 01/2011 EN edition
322
5.8.2 Safety instructions for emptying the waste tape container
5
Fig. 5.8 - 1 Safety instructions for emptying the waste tape container
The waste tape container must be pulled out of the component trolley for emptying. There is a risk
of catching your thumbs as you do so.
→ To avoid this risk, hold the waste tape container with your fingers on the underside of the han-
dle and place your thumb on the handle.
→ Do NOT put your thumbs in the gap between the tape container and waste tape container as
you could catch your thumbs if you do.
User manual SIPLACE X-series Tasks on the machine
From software version SR.70x.xx 01/2011 EN edition Carrying out a walk-through inspection
323
5.9 Carrying out a walk-through inspection
5.9.1 Checking the X feeder modules
5
Fig. 5.9 - 1 Checking the X feeder modules
(1) Flap
(2) Blade
(3) Status display
(4) LCD display
5
→ Check to see whether the tape foil removal container for the X tape feeder module is full.
Open the flap (item 1). Pull out the cover foil and cut it with scissors or on the integral blade
(item 2) on 8 and 12 mm X tape feeder modules.