00197446-02_UM_JTF_S_JTF-M_ X-Serie_S_de_en.pdf - 第130页

Setting up and Commissioning Retrofitting in the SIPLACE X-Series S 4.3.8 Installing the Manual Table 130 JEDEC Tray Feeder 4.3.8 4 . 3 . 8 I n s t a llin g t h e M a n u a l T a b le Installing the Manual Table Before i…

100%1 / 168
Setting up and Commissioning
4.3.7 Installing the Q10 Magazine (Option) Retrofitting in the SIPLACE X-Series S
JEDEC Tray Feeder 129
► The setting value (4) is 150 +/-0.2 mm.
You can adjust the height, where necessary, by removing or adding NC adjusting plates.
► Repeat this measurement on the inside of the gantry (5).
► Calibrate the position of the nozzle changer.
4.3.7
4.3.7 Installing the Q10 Magazine (Option)
Installing the Q10 Magazine (Option)
CAUTION
Crash hazard!
Do not place too many adjusting plates underneath.
Spacer plate [03104724-xx]
► Fix the spacer plate for the Q10 magazine
[03104724-xx] (1) to the fixation points using the two
M6x70 screws (2).
Setting up and Commissioning
Retrofitting in the SIPLACE X-Series S 4.3.8 Installing the Manual Table
130 JEDEC Tray Feeder
4.3.8
4.3.8 Installing the Manual Table
Installing the Manual Table
Before installing the manual table, the tape duct and the cutting device must be removed.
► Fix the Q10 magazine (1) to the spacer plate
[03104724-xx] (2) using the three screws (3).
NOTICE
Cables and hoses
► Before installing the table ensure to route all cables and hoses for the subsequent connec-
tion.
► Guide the pneumatic hose (1) out of the machine past
the rear side of the nozzle changer.
Ensure that the hose cannot be squeezed.
CAUTION
Back part, adjustable table fiducial
Do not operate the machine without the back part of the manual table or without the adjustable
table fiducial.
Setting up and Commissioning
4.3.8 Installing the Manual Table Retrofitting in the SIPLACE X-Series S
JEDEC Tray Feeder 131
4.3.8.1
4.3.8.1 Installation Positions of the Manual Table (Table Positions)
Installation Positions of the Manual Table (Table Positions)
4.3.8.2
4.3.8.2 Installing the Mounting Frame
Installing the Mounting Frame
Overview
The following installation positions for the manual table
are possible on SIPLACE X-Series S machines:
1. Installation position 2 (SIPLACE X4i S)
2. Installation position 3 (SIPLACE X2 S, X3 S, X4 S)
1. Centering bar
2. FCU
3. Front part
4. Back part