03217917-01-01E By DEK Technical Reference Manual Vol 1_enPDFA.pdf - 第245页

16 TRANSPORT RAILS MODULE 16.4 ADJUSTMENTS AND SETTINGS TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 245 Parallelism Check ► Using feeler gauges (6) check that the gap between both alignment pads (8) and the belt su…

16 TRANSPORT RAILS MODULE

16.4 ADJUSTMENTS AND SETTINGS

244 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019

► Place the jig (1) on the manual tooling plate (3) ensuring that the location pins (2) on the un-

derside of the jig (1) abut the front face of the manual tooling plate (3). Check there is no gap

using a 0.05mm feeler gauge.

► Secure the jig (1) to the front rail using the two jig to rail thumbscrews (4).

► Secure the jig (1) to the rising table using the two jig to table thumbscrews (5).

► Check that the location pins (2) are up against the front edge of the manual tooling plate using

a 0.05mm feeler gauge and there is no gap.

16 TRANSPORT RAILS MODULE

16.4 ADJUSTMENTS AND SETTINGS

TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 245

Parallelism Check

► Using feeler gauges (6) check that the gap between both alignment pads (8) and the belt sup-

port plate (7) of the front rail is 0.25mm +/-0.05mm.

8 6

► If adjustment is not necessary continue with Close Up.

16 TRANSPORT RAILS MODULE

16.4 ADJUSTMENTS AND SETTINGS

246 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019

Adjustment

► Using a 3mm Allen key slacken the four securing bolts (9) attaching the right hand transport

leg (10) to the carriage nut (11).

► Repeat previous Step on the left hand transport leg.

► Using a 4mm Allen key, through the access holes (12) in the board edge guide (13), slacken

the four rail securing bolts (two each side).

RH End LH End

► Loosen the two jig to rail thumbscrews on the rail setting jig.

► Adjust the front rail position to achieve the settings in Parallelism Check.

► Tighten the two jig to rail thumbscrews on the rail setting jig.

► Recheck the parallelism as detailed in Parallelism Check.