03217917-01-01E By DEK Technical Reference Manual Vol 1_enPDFA.pdf - 第274页
17 CAMERA SYSTEM MODULE 17.4 REPLACEMENT PROCEDURES 274 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 17.4 REPLACEMENT PROCEDURES 17.4.1 Camera W ARNING BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN TH…
17 CAMERA SYSTEM MODULE
17.3 ADJUSTMENTS AND SETTINGS
TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 273
► Using the Next or Previous button highlight Set Reference Position.
► Select Run Diagnost. The message ‘This Will Alter The Printer ConfigurationFile - Please
Confirm’ is displayed.
► Select Confirm.
► Reference Correct - Select Exit.
► Select Exit.
► Select Back.
17 CAMERA SYSTEM MODULE
17.4 REPLACEMENT PROCEDURES
274 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019
17.4 REPLACEMENT PROCEDURES
17.4.1 Camera
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
17.4.1.1 Removal
► Select Open Cover Commands.
► Select Carriage To Rear.
► Select Back.
► Select Shut Down.
► Select Continue.
► Switch the mains isolator to OFF and lockout the isolator.
► Open the printhead cover.
► Remove the stencil.
► To gain access to the camera for removal, move the camera forward and central over the
table by manually moving the camera carriage.
► Remove the following connectors from the rear of the camera unit:
●
10SK17
●
10SK13
► Loosen the two camera mount screws and lift the dovetail fixings to free the camera, lift the
camera out of the camera mount.
17 CAMERA SYSTEM MODULE
17.4 REPLACEMENT PROCEDURES
TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 275
4
3
1
2
1 Dovetaill Fixings Remain in Place 3 Camera Connectors
2 Camera Mount
(with Camera Removed)
4 Camera Securing Screws
17.4.1.2 Fitment
► Slide the camera into position in the dovetail ensuring that the end of th camera mount butts
against the right hand side of the dovetail and secure camera mount screws (2).
► Connect 10SK13 and 10SK17.
► Ensure that the cable-ties are secure and the cables are positioned to prevent any chaffing on
the board clamps or transport rails.
► Refit the stencil.
► Close the printhead cover.
► Remove the lock from the isolator.
► Power up the machine.
► Select Load Screen.
► The following adjustments/calibrations must be carried out:
●
Camera Reference Position Adjustment
●
Board Stop X Offset Check Calibration
●
Vision Calibration