CP40 service manual.pdf - 第130页
4. Feeder Base & ANC (CP-40) 4-3-2. Feeder I/F Board Cable Check Rear Front 4) Disconnect Connector on PCB. 5) Loosen Six Spherical Head Bolts to Disconnect F eeder I/F Board. 6) Replace New PCB and Assemble it accor…
4. Feeder Base & ANC
(CP-40)
4-3-1. Feeder I/F Board Replacement
Version Date WA QA CA Note
00 Nov04 O O O
1) Using Teaching Box, Move Head to the
Rear.
2) Turn Conveyor Width Adjusting Handle to
the Right-hand to Widen Conveyor Width as
Widely as Possible.
Decrease
Increase
<Conveyor Width Adjusting Handle>
J1301706
3) Loosen Seven M3*6 Toras Bolts to Open
Chip Cover on the Inner Left-side of
Equipment.
<Chip Cover Side>
J2102037
<Feeder I/F Board>
4. Feeder Base & ANC
(CP-40)
4-3-2. Feeder I/F Board Cable Check
Rear
Front
4) Disconnect Connector on PCB.
5) Loosen Six Spherical Head Bolts to
Disconnect Feeder I/F Board.
6) Replace New PCB and Assemble it
according to Reverse Procedures of
Disassembly.
<Feeder I/F Board>
J9800394
Version Date WA QA CA Note
00 Nov04 O O O
4. Feeder Base & ANC
(CP-40)
7 8
CYLINDER BLOCK
ANC CLOSE
ANC OPEN
Feeder Power Cable Ass'y
J2102108
ANC Sensor Cable Ass'y
J2102104
Feeder I/F Board
J9800394
15
16
Cylinder
J1301689
Version Date WA QA CA Note
00 Nov04 O O O