CP40 service manual.pdf - 第138页
4. Feeder Base & ANC (CP-40) Display 1 Display 5 Display 3 Display 4 Display 2 Version Date WA QA CA Note 00 Nov04 O O O
4. Feeder Base & ANC
(CP-40)
Select "Mark Type 1" and Set as Follows.
Register ANC Type and Select "Add New"(If ANC Type has been Registered, Use it).
Select "ANC Mark Type".
Select "Edit".
When the below Window is Appeared, Perform Setting and Test as Follows.
In Form Data, Input 2.5 in Width Column(Display ).
In Search Area, Input X, Y, Width and Height as Shown in Figure(Display ).
Select "Tuning"(Display ).
Select "Test"(Display ).
If Fiducial is Completed Successfully, Good Message is Displayed in Vision Status(Display ).
In Fiducial Mark Vision Data Window, Select "OK" to Finish.
In Fiducial Mark Data Window, Select "OK" to Finish.
Pos. 2
CP40 ANC
2.5 mm
2.5 mm
Pos. 1
Version Date WA QA CA Note
00 Nov04 O O O
4. Feeder Base & ANC
(CP-40)
Display 1
Display 5
Display 3
Display 4
Display 2
Version Date WA QA CA Note
00 Nov04 O O O
4. Feeder Base & ANC
(CP-40)
In Fiducial Mark Window, Select "Scan Test" as Follows and Perform Test Repeatedly.
=> Perform Test Repeatedly until Scan Data of X and Y is within +-0.01mm(Display ).
Take Cursor on Pos 1(Display ).
In Teaching, Select "Move"(Display ) .
Select "OK" and then "Auto Position"(Display ).
Display 4
Display 1
Display 2
Display 3
Version Date WA QA CA Note
00 Nov04 O O O