CP40 service manual.pdf - 第149页
4. Feeder Base & ANC (CP-40) <Single-stage Conveyor> <2-stage Conveyor> <3-stage Conveyor> OUT SENSOR PLACE STOPPER HOLE FIXER INPUT SEN SOR #Based on White Block PLACE SENSOR WAIT SENSOR 100mm 45mm…
4. Feeder Base & ANC
(CP-40)
INPUT SENSOR
PLACE STOPPER
HOLE
FIXER
OUTPUT SENSOR
PLACE SENSOR
WAIT SENSOR
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
J9800393
Conveyor I/F Board Ass'y
19 Up
20 Down
J3212025A
SENSOR (Former J1301569)
CN29 CV17-1
CN30 CV18-1
CN31 CV19-1
CN32 CV20-1
Version Date WA QA CA Note
00 Nov04 O O O
4-3-8. Conveyor I/F Board Cable Check
4. Feeder Base & ANC
(CP-40)
<Single-stage Conveyor> <2-stage Conveyor> <3-stage Conveyor>
OUT SENSOR PLACE STOPPER
HOLE
FIXER
INPUT SENSOR
#Based on White Block
PLACE SENSOR WAIT SENSOR
100mm 45mm
45mm 15mm 950mm 0mm
<Fig. 1> CP-40L(V) Conveyor Right => Left Assembly View
<Working Procedures>
1)As Shown in Above Figure, Secure Sensors on Each Position Properly.
2)Secure White Block(for Securing Place Stopper) Between Single-stage and 2-stage Conveyors according
to Each Dimension.
3)Secure Place Stopper on Left Block.
4)Exchange the Left and the Right of AC Motor.
5)Set PCB Origin to Front Left and the Direction of 2-stage Conveyor to CCW.
-.Refer to Fig. 2.
Version Date WA QA CA Note
00 Nov04 O O O
4-3-9. Conveyor Right => Left Change
4. Feeder Base & ANC
(CP-40)
Origins
Coordinate System
Front Left
PCB Origin
603.375
Conveyor Direction
CCW
XY:
121.570
mm
X
Y
<Fig. 2> PCB Origin Setting
6)Exchange Locations of Sensor Connectors on Conveyor I/F Board.
CN29(IN SENSOR)
CN30(WAIT SENSOR)
CN31(PLACE SENSOR)
CN32(OUT SENSOR)
Conveyor I/F Board
Version Date WA QA CA Note
00 Nov04 O O O