CP40 service manual.pdf - 第144页
4. Feeder Base & ANC (CP-40) 7. Remove Wire Harness of Cylinder Block. 8. Loosen Eight M4*6 Flush B olts(for Securing Chip Cover) in the Rear of Cylinder Block. 9. Loosen Two H exagon Wrench Bolts(for S ecuring) in t…
4. Feeder Base & ANC
(CP-40)
5. Using L-Wrench and Driver Handle, Loosen Eight M8*25 Hexagon
Wrench Bolts.
(T-Wrench(6mm) can also be Used)
6. Lift and Remove Feeder Base with Both Hands.
(Caution) Care should be Taken not to Get Injured in the Waist.
5
Driver Handle
L-Wrench(6mm)
Hexagon Wrench Bolt
M8*25 8ea
Version Date WA QA CA Note
00 Nov04 O O O
4. Feeder Base & ANC
(CP-40)
7. Remove Wire Harness of Cylinder Block.
8. Loosen Eight M4*6 Flush Bolts(for Securing Chip
Cover) in the Rear of Cylinder Block.
9. Loosen Two Hexagon Wrench Bolts(for Securing) in
the Right- and Left-hand Sides of Cylinder Block
Respectively to Lift and Carry.
7
* Press Connect with Thumb and Pull it
to Disconnect.
Hexagon Wrench Bolts for
Securing Cylinder
Block(2ea for Left/Right
Sides Respectively)
9
Right Side
Left Side
Version Date WA QA CA Note
00 Nov04 O O O
4. Feeder Base & ANC
(CP-40)
Version Date WA QA CA Note
00 Nov04 O O O
10. Loosen Two Bolts in the Bottom(refer to the Above Figure) to Replace Cylinder Block of Faulty Area.
(* Take Note of Locations of Bolts.)
Four Multi Cylinders Make a Set, which is a Unit for Replacement.
11. For Assembly, Perform Reverse Procedures.
J1301387
Multi Cylinder (Woosung)
10
Bolt for Securing Multi Cylinder
(2ea)