CP40 service manual.pdf - 第93页
1. Head Part (CP-40) Fitting #1 Fitting #2 M4 Hexagon Wrench Bolt * 2ea Φ 3N U T *2 e a M4 Hexagon Wrench Φ 6S p a n n e r 7. Loosen Two Φ 3 Nuts Using Φ 6 Spanner. With 3mm Wrench, Loosen Two M3*8 Hexagon Wrench Bolts. …
1. Head Part
(CP-40)
Version Date WA QA CA Note
00 Nov04 O O O
1. Move Head to the Rear Acryl Cover.
2. Put Off Power
Switch.
3. Remove Air.
4. Disconnect Four Bolts from the Upper Cover of Head I/F
Board.
5. Disconnect Head CN11~13(Solenoid Cable) and
CN14~16(Generator Cable).
CN11~CN16
HEAD I/F BOARD
J9800392
Head I/F Cover
J7152011B
1-3-5. Vacuum Generator Replacement
1. Head Part
(CP-40)
Fitting #1
Fitting #2
M4 Hexagon Wrench
Bolt * 2ea
Φ
3NUT*2ea
M4 Hexagon Wrench
Φ
6Spanner
7. Loosen Two
Φ
3 Nuts Using
Φ
6 Spanner.
With 3mm Wrench, Loosen Two M3*8 Hexagon
Wrench Bolts.
6. Disconnect Fitting #1 and #2 from Vacuum
Generator.
Version Date WA QA CA Note
00 Nov04 O O O
1. Head Part
(CP-40)
8. Replace Faulty Part Among H1~H3 of Vacuum Generator.
9. In Case of Weak Blow, Adjust it Using Adjust Screw.
H1
H2
H3
Blow Adjust Screw
Block End of Compliance with Finger.
Vacuum Generator
J6707016A
Version Date WA QA CA Note
00 Nov04 O O O