cp45ref.pdf - 第102页
Samsung Component Placer CP-45F(V)/FS Refer ence Manual 2-48 Please contact our C/S. $c000 Error occurred while the profile of speed acceleration and deceleration at $A was set. [Problem] The factory setting speed profil…
System Messages of the MMI and Solutions
2-47
S/W error
[Solution]
Please contact our C/S.
$bf30 Error was detected in the sequence table in the TskGan.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$bf31 Error was detected in the scheduler table in the TskGan.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$bf32 Error was detected while the sequence in the TskGan was executed.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$bf80 Can't find the TskTray data.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$bfff Undefined ERROR.
[Problem]
S/W error
[Solution]
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-48
Please contact our C/S.
$c000 Error occurred while the profile of speed acceleration and deceleration at $A was set.
[Problem]
The factory setting speed profile is incorrect
S/W error
[Solution]
Please contact our C/S.
$c001 Error occurred while the profile of uniform speed at $A was set.
[Problem]
The factory setting speed profile is incorrect
S/W error
[Solution]
Please contact our C/S.
$c002 Error occurred while $A was setting the Home command.
[Problem]
The factory setting speed profile is invalid
S/W error
[Solution]
Please contact our C/S.
$c003 Error occurred in $A during homing.
[Problem]
An error occurred due to sensor or other reasons during homing.
[Solution]
Please contact our C/S.
$c004 Error occurred in $A during homing.
[Problem]
System Messages of the MMI and Solutions
2-49
An error occurred due to sensor or other reasons during homing.
[Solution]
Please contact our C/S.
$c005 Error was detected while $A is waiting for the Comp.
[Problem]
The specified axis did not pass through the specified position.
Invalid Config or Factory DB setting.
Invalid Servo Pack setting.
Bad wiring related to motor
[Solution]
Please contact our C/S
$c006 Minus S/W Limit is sensed at $A.
[Problem]
The specified axis is sensed at – S/W limit.
[Solution]
Change the limit value
$c007 Plus S/W Limit is sensed at $A.
[Problem]
The specified axis is sensed at + S/W limit.
[Solution]
Change the limit value
$c008 Incorrect scale value was found during coordinate calculation.
[Problem]
The scale value of the specified axis is incorrect.
Error in Config or Factory DB setting
[Solution]
Please contact our C/S