cp45ref.pdf - 第105页
System Messages of the MMI and Solutions 2-51 [Problem] An error occurred during auto limit search. [Solution] Check the operation of the limit sensor . Please contact our C/S. $c7ff During a manual operation, an err or …
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-50
$c009 %d error occurred during the wait for the flag(%x), which indicates the operation
of motor is finished.
[Problem]
Error in Config or Factory DB setting
S/W or H/W error
[Solution]
Check motor related wiring and axis board
Please contact our C/S
$c00a Error occurred during the setting of flag(%x), which indicates the operation of
motor is finished.
[Problem]
S/W error
[Solution]
Please contact our C/S
$c00b Error occurred while the axis board(X3203) was approached.
[Problem]
1. H/W error
[Solution]
Replace the axis board
Please contact our C/S
$c00c Manual operation is possible only after all the axes have returned home.
[Problem]
Manual operation is possible only after all axes have returned home.
[Solution]
Try other operations after homing
$c00d Error occurred while the axis limit was searched automatically.
System Messages of the MMI and Solutions
2-51
[Problem]
An error occurred during auto limit search.
[Solution]
Check the operation of the limit sensor.
Please contact our C/S.
$c7ff During a manual operation, an error occurred in motor driving.
[Problem]
In the case of moving to a place where there is mechanical interference.
H/W error
[Solution]
Check if there is any mechanical interference.
Please contact our C/S.
$c800 CALC_MOUNT_POS_ERROR.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$c801 Undefined WaitPosition Type is set.
[Problem]
1. S/W error
[Solution]
Change the wait position type in the PCB board.
Please contact our C/S.
$cfff Error was detected in the coordinate calculation.
[Problem]
S/W error
[Solution]
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-52
Please contact our C/S.
$d102 Timeout occurred during DPRAM communication.
[Problem]
Communication between the MMI and the VME is interrupted
The DPRAM board is bad
[Solution]
Please contact our C/S.
Replace the DPRAM board
$d103 During DPRAM communication, checksum error was detected in the %d frame
while the %x command was transmitted.
[Problem]
The DPRAM board is bad
Checksum error occurred during the communication between the MMI and the VME
[Solution]
Replace the DPRAM board
Please contact our C/S.
$d107 Invalid frame number was detected during DPRAM communication.
[Problem]
The DPRAM board is bad
Communication error occurred during the communication between the MMI and the
VME
[Solution]
Replace the DPRAM board
Please contact our C/S.
$d108 During DPRAM communication, the error of exceeding the retry count was
detected.
[Problem]