cp45ref.pdf - 第107页
System Messages of the MMI and Solutions 2-53 The DPRAM board is bad Communication error occurred during the communication between the MM I and the VME [Solution] Replace the DPRAM board Please contact our C/S. $d1 10 Re…
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-52
Please contact our C/S.
$d102 Timeout occurred during DPRAM communication.
[Problem]
Communication between the MMI and the VME is interrupted
The DPRAM board is bad
[Solution]
Please contact our C/S.
Replace the DPRAM board
$d103 During DPRAM communication, checksum error was detected in the %d frame
while the %x command was transmitted.
[Problem]
The DPRAM board is bad
Checksum error occurred during the communication between the MMI and the VME
[Solution]
Replace the DPRAM board
Please contact our C/S.
$d107 Invalid frame number was detected during DPRAM communication.
[Problem]
The DPRAM board is bad
Communication error occurred during the communication between the MMI and the
VME
[Solution]
Replace the DPRAM board
Please contact our C/S.
$d108 During DPRAM communication, the error of exceeding the retry count was
detected.
[Problem]
System Messages of the MMI and Solutions
2-53
The DPRAM board is bad
Communication error occurred during the communication between the MMI and the
VME
[Solution]
Replace the DPRAM board
Please contact our C/S.
$d110 Received undefined command from the MMI.
[Problem]
The DPRAM board is bad
The versions of MMI and the VME are incompatible
Communication error occurred during the communication between the MMI and the
VME
[Solution]
Replace the DPRAM board
Check the versions of the MMI and the VME and use the correct version.
Please contact our C/S.
$d111 Received undefined communication command from the MMI.
[Problem]
The DPRAM board is bad
The versions of the MMI and the VME are incompatible
Communication error occurred during the communication between the MMI and the
VME
[Solution]
Replace the DPRAM board
Check the versions of the MMI and the VME and use the correct version.
Please contact our C/S.
$e000 At PC=%x, an access fault error occurred while the %x address was to be used.
[Problem]
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-54
H/W or S/W defect
[Solution]
Please contact our C/S.
$e001 At PC = %x Addr = %x, error of dividing by 0 occurred.
[Problem]
S/W defect
[Solution]
Please contact our C/S.
$e011 Access fault occurred in the vision board.
[Problem]
Vision board defect
[Solution]
Please contact our C/S.
Replace the board
$e012 Access fault occurred in the IO board.
[Problem]
IO board defect
[Solution]
Please contact our C/S.
Replace the board
$e013 Access fault occurred in the DPRAM board.
[Problem]
DPRAM board defect
[Solution]
Please contact our C/S.
Replace the board