cp45ref.pdf - 第126页
Samsung Component Placer CP-45F(V)/FS Refer ence Manual 2-72 $fb0f %d error occurred when the Pa ckSsaChip DB memory was cancelled. [Problem] S/W error [Solution] Please contact our C/S. $fb10 %d error occurred when the …
System Messages of the MMI and Solutions
2-71
$fb0a %d error occurred when the Tray Feeder DB memory was cancelled.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$fb0b %d error occurred when the Part DB memory was cancelled.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$fb0c %d error occurred when the PackCom DB memory was cancelled.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$fb0d %d error occurred when the PackSsaLl DB memory was cancelled.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$fb0e %d error occurred when the PackSsaBga DB memory was cancelled.
[Problem]
S/W error
[Solution]
Please contact our C/S.
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-72
$fb0f %d error occurred when the PackSsaChip DB memory was cancelled.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$fb10 %d error occurred when the PackChuck DB memory was cancelled.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$fb11 %d error occurred when the PackCa DB memory was cancelled.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$fb12 %d error occurred when the PackQa DB memory was cancelled.
[Problem]
S/W error
[Solution]
Please contact our C/S.
Hardware Troubleshooting
3-1
Chapter 3. Hardware Troubleshooting
3.1. Power Inspection
Ready Switch
Check the functioning of switch
Isolation Switch
Main Circuit Breaker
Main Start Switch
- Check the EMG Front switch
- Check the EMG Rear switch
- Check the CP1 switch (TURN ON)
- Check the CP2 switch(TURN ON)
- Check the CR1-1,CR1-2,CR3 switches
Operating
- Check the CR3 relay
- Check the CONV I/F CN10
connections.
- Check the CR2-1, CR2-2 switches
Powering On (AC 220V) Check the status of power supply
Check the functioning of switch
Figure 3-1. Power Inspection
Warning
As high voltage current flows in the power supply area of
the Component Placer, if a part of human body or other
conductors touch the equipment, it could result in severe
injuries.
As charged electrons could cause electric shock for a few
minutes after the Component Placer is turned off, the
machine must be handled only by qualified personnel. And
the inspection of the machine must be done while power
supply is turned off and the power plug is completely
disconnected.
CR4
230V