cp45ref.pdf - 第109页
System Messages of the MMI and Solutions 2-55 $e014 Access fault occurred in the Axis1 board. [Problem] Axis1 board defect [Solution] Please contact our C/S. Replace the board $e015 Access fault occurred in the Axis2 boa…
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-54
H/W or S/W defect
[Solution]
Please contact our C/S.
$e001 At PC = %x Addr = %x, error of dividing by 0 occurred.
[Problem]
S/W defect
[Solution]
Please contact our C/S.
$e011 Access fault occurred in the vision board.
[Problem]
Vision board defect
[Solution]
Please contact our C/S.
Replace the board
$e012 Access fault occurred in the IO board.
[Problem]
IO board defect
[Solution]
Please contact our C/S.
Replace the board
$e013 Access fault occurred in the DPRAM board.
[Problem]
DPRAM board defect
[Solution]
Please contact our C/S.
Replace the board
System Messages of the MMI and Solutions
2-55
$e014 Access fault occurred in the Axis1 board.
[Problem]
Axis1 board defect
[Solution]
Please contact our C/S.
Replace the board
$e015 Access fault occurred in the Axis2 board.
[Problem]
Axis2 board defect
[Solution]
Please contact our C/S.
Replace the board
$e016 Access fault occurred in the Axis3 Board.
[Problem]
Axis3 board defect
[Solution]
Please contact our C/S.
Replace the board
$e017 Access fault occurred in the Axis4 board.
[Problem]
Axis4 board defect
[Solution]
Please contact our C/S.
Replace the board
$e100 %x error occurred in the IO board %d .
[Problem]
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-56
I/O I/F board communication defect
[Solution]
Please contact our C/S.
Replace the board
$e101 Error in vision result value.
[Problem]
H/W or S/W error
[Solution]
Please contact our C/S.
Replace the board
$e200 Air pressure is not supplied to the equipment.
[Problem]
Air pressure is not supplied to the equipment.
Defect in the air pressure check sensor or incorrect setting
[Solution]
Supply air pressure
Check the setting of the air pressure supply sensor and check if it operates correctly.
$e300 Error occurred in $A axis.
[Problem]
H/W or S/W error
[Solution]
Please contact our C/S.
Replace the board
$e800 Motor setting of $A axis is invalid.
[Problem]
H/W or S/W error
[Solution]