cp45ref.pdf - 第70页
Samsung Component Placer CP-45F(V)/FS Refer ence Manual 2-16 $4000 Components that can't be operated together exist in a cycle. [Problem] The components that can't be operated together exist in a cycle [Solutio…
System Messages of the MMI and Solutions
2-15
$3402 Can't lower the work stopper.
[Problem]
The mounting stopper can't be lowered due to mechanical interference
The position of the mounting stopper is incorrect
[Solution]
Remove the mechanical interference.
Check if the sensor operates properly and adjust its position.
$3501 Can't raise the out stopper.
$3502 Can't lower the out stopper.
$3600 AREA_PCB_OVER_MAXIMUM_WARNING.
$3601 MOUNTING_OVER_MAXIMUM_WARNING.
$3700 SMEMA_SIGNAL_TIMEOUT_ERROR.
$3701 Time out error occurred on the conveyor during operation.
[Problem]
Time out occurred during the transfer of PCB on the conveyor.
[Solution]
Correct the problem and restart.
$3fff CONV_NOT_DEFINED
[Problem]
The conveyor related setting is not correct.
[Solution]
Please contact our C/S.
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-16
$4000 Components that can't be operated together exist in a cycle.
[Problem]
The components that can't be operated together exist in a cycle
[Solution]
Divide one cycle into two and operate.
$4001 Error occurred during a manual operation.
[Problem]
An error occurred during a manual operation.
[Solution]
Please contact our C/S.
$4002 Undefined operation mode is used.
[Problem]
An undefined operation mode is used.
[Solution]
Set the operation mode ( Normal/Dry …) again.
Please contact our C/S.
$4004 Method of deciding bad mark position is invalid.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$4005 Undefined door method.
[Problem]
The door type is set incorrectly
[Solution]
Set the door again in the system setup.
System Messages of the MMI and Solutions
2-17
$4110 TOO_MANY_DUMP.
$4200 $H is trying to pick up a component from the position of %d which is beyond the
limit of %d.
[Problem]
When the head is to pick up a component, the height is beyond the S/W limit.
[Solution]
Set the S/W limit again in the system head setting.
$4201 $H is trying to mount a component on the position of %d which is beyond the limit
of %d.
[Problem]
When the head is to mount a component, the height is beyond the S/W limit.
[Solution]
Set the S/W limit again in the system head setting.
$4202 $H is trying to change the nozzle on the position of %d which is beyond the limit
of %d.
$4300 $A axis is sensed in - S/W Limit when the jog box is used.
[Problem]
When the jog box is used for moving, the S/W limit is sensed.
[Solution]
Change the S/W limit value.
$4301 $A axis is sensed in + S/W Limit when the jog box is used.
[Problem]
When the jog box is used for moving, the S/W limit is sensed.
[Solution]
Change the S/W limit value.