cp45ref.pdf - 第106页
Samsung Component Placer CP-45F(V)/FS Refer ence Manual 2-52 Please contact our C/S. $d102 Time out occurred during DPRAM comm unication. [Problem] Communication between the MMI and the VME is in terrupted The DPRAM boar…
System Messages of the MMI and Solutions
2-51
[Problem]
An error occurred during auto limit search.
[Solution]
Check the operation of the limit sensor.
Please contact our C/S.
$c7ff During a manual operation, an error occurred in motor driving.
[Problem]
In the case of moving to a place where there is mechanical interference.
H/W error
[Solution]
Check if there is any mechanical interference.
Please contact our C/S.
$c800 CALC_MOUNT_POS_ERROR.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$c801 Undefined WaitPosition Type is set.
[Problem]
1. S/W error
[Solution]
Change the wait position type in the PCB board.
Please contact our C/S.
$cfff Error was detected in the coordinate calculation.
[Problem]
S/W error
[Solution]
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-52
Please contact our C/S.
$d102 Timeout occurred during DPRAM communication.
[Problem]
Communication between the MMI and the VME is interrupted
The DPRAM board is bad
[Solution]
Please contact our C/S.
Replace the DPRAM board
$d103 During DPRAM communication, checksum error was detected in the %d frame
while the %x command was transmitted.
[Problem]
The DPRAM board is bad
Checksum error occurred during the communication between the MMI and the VME
[Solution]
Replace the DPRAM board
Please contact our C/S.
$d107 Invalid frame number was detected during DPRAM communication.
[Problem]
The DPRAM board is bad
Communication error occurred during the communication between the MMI and the
VME
[Solution]
Replace the DPRAM board
Please contact our C/S.
$d108 During DPRAM communication, the error of exceeding the retry count was
detected.
[Problem]
System Messages of the MMI and Solutions
2-53
The DPRAM board is bad
Communication error occurred during the communication between the MMI and the
VME
[Solution]
Replace the DPRAM board
Please contact our C/S.
$d110 Received undefined command from the MMI.
[Problem]
The DPRAM board is bad
The versions of MMI and the VME are incompatible
Communication error occurred during the communication between the MMI and the
VME
[Solution]
Replace the DPRAM board
Check the versions of the MMI and the VME and use the correct version.
Please contact our C/S.
$d111 Received undefined communication command from the MMI.
[Problem]
The DPRAM board is bad
The versions of the MMI and the VME are incompatible
Communication error occurred during the communication between the MMI and the
VME
[Solution]
Replace the DPRAM board
Check the versions of the MMI and the VME and use the correct version.
Please contact our C/S.
$e000 At PC=%x, an access fault error occurred while the %x address was to be used.
[Problem]