cp45ref.pdf - 第50页

Samsung Component Placer CP-45F(V)/FS Refer ence Manual 1-24 1.2.7.2. Air Filter & Auto Drainer Inspection  Check to see if there are any moisture or water inside the air filter .  Check to see if the filter elemen…

Preventive Maintenance

1-23

 Remove the LED assembly by removing the four screws to the sides of the assembly.

 Clean the cover glass using a soft cloth.

 Assemble the LED assembly by screwing the four screws.

1.2.6.2. Camera Lens

Inspection

 Check to see if there are any dust or contamination on the camera lens.

Solution

 Remove the LED assembly by removing the four screws to the sides of the assembly.

 Clean the camera lens by using a soft cloth.

 Assemble the LED assembly by screwing the four screws.

1.2.7. Pneumatics

1.2.7.1. Pressure Settings

Inspection

 Check to see if the supplied pneumatics is appropriate for the configured pressure.

Figure 1-17. Inspection for Pneumatics

Solution

 Adjust the pneumatics setting by rotating the regulator CW(Clockwise) or

CCW(Counter Clockwise).

Caution

The cover glass is fragile. Take care.

Caution

Setting the pressure incorrectly could harm the machine

performance. Set the pressure correctly.

Pressure Gauge & Auto Switch

Air Filter & Auto Drainer

Regulator

Pressure Gauge

Samsung Component Placer CP-45F(V)/FS Reference Manual

1-24

1.2.7.2. Air Filter & Auto Drainer

Inspection

 Check to see if there are any moisture or water inside the air filter.

 Check to see if the filter element is clogged.

 Check for discoloration of the filter element.

 Check to see if moisture is being properly drained out through the drainer.

 Check to see if the tube is properly connected to the drainer.

Solution

How to change the air filter

Warning

Changing the air filter without cutting off the air pressure

could result in personal injury.

Be sure to cut off air pressure before chaing the air filter.

Preventive Maintenance

1-25

 Lower the locking mechanism or handle for the air filter tray and turn it sideways to

remove the tray.

 Remove the contaminated filter element.

 Install the new filter element reversing the above procedures.

 Reassemble the tray.

1.2.7.3. Gauge and Pressure Switch

Inspection

 Check to see if the pressure switch has been automatically activated by low pressure.

Solution

 If it does not function properly, contact the service center for service.

1.2.7.4. Connections and Fittings

Inspection

 Check for unusual wear in the tubes.

 Check to see if any tubes and fittings are loose, and make sure there are no leaks.

Solution

 Replace the tube if unusual wear is discovered.

 Tighten any loose fitting.

1.2.8. Component Feeding Sub-Systems (Feeders)

 Please refer to the manuals for information on each component feeding sub-systems.