cp45ref.pdf - 第110页
Samsung Component Placer CP-45F(V)/FS Refer ence Manual 2-56 I/O I/F board communication defect [Solution] Please contact our C/S. Replace the board $e101 Err or in vision r esult value. [Problem] H/W or S/W error [Solut…
System Messages of the MMI and Solutions
2-55
$e014 Access fault occurred in the Axis1 board.
[Problem]
Axis1 board defect
[Solution]
Please contact our C/S.
Replace the board
$e015 Access fault occurred in the Axis2 board.
[Problem]
Axis2 board defect
[Solution]
Please contact our C/S.
Replace the board
$e016 Access fault occurred in the Axis3 Board.
[Problem]
Axis3 board defect
[Solution]
Please contact our C/S.
Replace the board
$e017 Access fault occurred in the Axis4 board.
[Problem]
Axis4 board defect
[Solution]
Please contact our C/S.
Replace the board
$e100 %x error occurred in the IO board %d .
[Problem]
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-56
I/O I/F board communication defect
[Solution]
Please contact our C/S.
Replace the board
$e101 Error in vision result value.
[Problem]
H/W or S/W error
[Solution]
Please contact our C/S.
Replace the board
$e200 Air pressure is not supplied to the equipment.
[Problem]
Air pressure is not supplied to the equipment.
Defect in the air pressure check sensor or incorrect setting
[Solution]
Supply air pressure
Check the setting of the air pressure supply sensor and check if it operates correctly.
$e300 Error occurred in $A axis.
[Problem]
H/W or S/W error
[Solution]
Please contact our C/S.
Replace the board
$e800 Motor setting of $A axis is invalid.
[Problem]
H/W or S/W error
[Solution]
System Messages of the MMI and Solutions
2-57
Please contact our C/S.
Replace the board
$e801 Can't check the speed profile of $A axis.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$e802 Can't check the home escape range of $A axis.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$e803 Error in the Electronic gear ratio of $A axis.
[Problem]
Error in Config factory setting
S/W error
[Solution]
Check the Config and factory setting
Please contact our C/S.
$e804 Can't check the scale of $A axis.
[Problem]
S/W error
[Solution]
Please contact our C/S.
$e805 Can't check the safe position of $A axis.
[Problem]