cp45ref.pdf - 第58页
Samsung Component Placer CP-45F(V)/FS Refer ence Manual 2-4 When an axis is to move, other axes are not in safe positions. [Solution] Please contact our C/S. $0803 During a manual operation, the %d axis interfer es when …
System Messages of the MMI and Solutions
2-3
[Solution]
Close the front door.
Check the sensor or the wiring area.
$0021 Rear door is open.
[Problem]
The rear door is open.
The rear door sensor or the wiring area is wrong.
[Solution]
Close the rear door.
Check the sensor or the wiring area.
$0100 Vme Module Ver % d is executed.
[Problem]
It is only for checking when the VME Program is started, it is a regular operation.
[Solution]
$0800 Other axes interfere when the $A axis is to be moved.
[Problem]
Other axes are not in safe positions when an axis is to move.
[Solution]
Please contact our C/S.
$0801 AXIS_SAFE_POS_MOVE_ERROR.
[Problem]
An error occurs when a certain axis is to be moved to a safe position.
[Solution]
Please contact our C/S.
$0802 Other axes interfere when the $A axis is to be moved.
[Problem]
Samsung Component Placer CP-45F(V)/FS Reference Manual
2-4
When an axis is to move, other axes are not in safe positions.
[Solution]
Please contact our C/S.
$0803 During a manual operation, the %d axis interferes when the %d side is to be
moved.
[Problem]
When an axis is to move, other axes are not in safe positions.
[Solution]
Please contact our C/S.
$0804 During a manual operation, the %d axis interferes when the %d side or the %d axis
is to be moved.
[Problem]
When an axis is to move, other axes are not in safe positions.
[Solution]
Please contact C/S.
$1000 - H/W Limit is sensed at the $A axis.
[Problem]
The H/W sensor in - direction is sensed at the specified axis.
[Solution]
Move each axis to a position that can't be sensed by the H/W limit sensor.
Reset the S/W limit of the specified axis.
System Messages of the MMI and Solutions
2-5
$1001 + H/W Limit is sensed at the $A axis.
[Problem]
The H/W limit sensor in + direction is sensed at the specified axis.
[Solution]
Move each axis to a position that can't be sensed by the H/W limit sensor.
Reset the S/W limit of the specified axis.
$1002 Alarm is sensed at the $A axis.
[Problem]
In the case of an axis, excessive pressing can cause this.
A motor error occurred at the specified axis.
[Solution]
Check the height during the corresponding operation at the Z axis.
If it is due to other reasons or if it happens repeatedly, please contact our C/S.
$1003 $A axis did not stop within the set time.
[Problem]
The specified axis did not stop within the set time after it moved.
Bad wiring related to the axis.
Bad board related to the axis
[Solution]
Check if there is any mechanical interference blocking the movement of the specified axis.
Check the wiring.
Replace the axis board.