UV-9+Cure+Module+7269348_B+Manual.pdf - 第83页
5.7.4.4 PLC Message Screen The PLC Messages screen d isplays th e messages of the lane contro ller that are generat ed during o ven operation. Select the Message button the "My Oven" m enu to open this screen. …
5.7.4.3 UV Lamp Counter Screen
Click on Counter in the "My Oven" menu to open the Counter screen.
Top Lamp Only
Top and Bottom Lamps
Name
Description
Reset top
Resets the top UV lamp counter to zero.
Reset bottom
Resets the bottom UV lamp counter to zero.
Top Lamp – Standby (mn)
Displays the Top Lamp running time in standby mode.
Top Lamp – Run (mn)
Displays the Top Lamp running time in run (production) mode.
Top Lamp - Start
Displays the number of starts for the Top Lamp.
Bottom Lamp – Standby (mn)
Displays the Bottom Lamp running time in standby mode.
Bottom Lamp – Run (mn)
Displays the Bottom Lamp running time in run (production) mode.
Bottom Lamp - Start
Displays the number of lamp starts for the Bottom Lamp.
Figure 5-20 UV Lamp Counter
NOTE It is recommended that you reset the counters when the lamps are changed.
5-20 Operation
5.7.4.4 PLC Message Screen
The PLC Messages screen displays the messages of the lane controller that are generated during oven
operation. Select the
Message button the "My Oven" menu to open this screen.
Figure 5-21 PLC Message Screen
Operation 5-21
5.7.4.5 SMEMA Screen
The SMEMA screen displays the various SMEMA related setpoints. Select the SMEMA button on the
"My Oven" menu to open this screen.
Name Description
Pcb Interval
Time interval between boards (even if the Upstream Available signal
is on).
Note: this feature is active only if ONE PCB is not active (grayed out). If
one PCB is active, the oven will not accept a new board until the
previous board has exited.
Pcb Sensor Delay On (s)
Delay time before attempting to detect a board at the oven entrance.
Pcb Sensor Delay Off (s)
Delay time before attempting to detect a board at the oven exit.
Standby (mn)
Displays the standby setpoint.
The maximum time without board detection before entering Standby
Mode.
Time delay stop UV (mn)
Displays the Time Delay Stop UV setpoint.
The maximum time without board detection before oven stops.
N-1 not ready (s)
Displays the N-1 not ready setpoint.
The maximum time without a signal from the downstream equipment
before the alarm sounds.
Figure 5-22 SMEMA Screen
5-22 Operation