OptimaUserManual.pdf - 第11页

INTRO DUCT IO N Opti ma User M anual 5 Insta lling the O ptima H ardware Optima prog r ammers arriv e wi t h the follow ing components: x Program mer base x Optional TOPs x 25 pin, 1:1 parall e l cable, 32” l ength x Opt…

INTRODUCTION

Optima User Manual

Computer Requirements

In order to use your programmer successfully, you will need the following:

x Windows-based PC, AT, 486, Pentium, Laptop, or Notebook

x 640K RAM (minimum)

x Hard disk with at least 10 Megabytes of available space

x VGA or LCD

INTRODUCTION

Optima User Manual

Installing the Optima Hardware

Optima programmers arrive with the following components:

x Programmer base

x Optional TOPs

x 25 pin, 1:1 parallel cable, 32” length

x Optima-Booster

x Power cord

x Power supply (Plus 48, Optima, Optima Light, Dual)

x Optima Windows software on CD-ROM

x Optima User Manual

To prepare the Optima programmer for use, remove all the components from the

packaging material and verify that they are in good repair.

Connecting the Programmer to Your Computer

Connect the programmer to your computer by following these steps:

1. Make sure that both the computer and programmer power switches are turned

OFF.

2. Connect one end of the parallel cable to the port on the rear of the programmer.

3. Connect the other end of the parallel cable to the parallel port of your computer.

If your computer has more than one parallel port, any empty port may be used.

Note: Some parallel ports have hardware characteristics that may

cause problems communicating with the programmer. If you

see the message “Found slow printer port” during

installation, install the Optima-Booster supplied with your

programmer. Follow the instructions “Installing the

Optima-Booster for a Slow Printer Port.”

INTRODUCTION

Optima User Manual

4. Install the power supply:

x For Plus 48, Optima, Optima Light, and Dual programmers: Insert the small

DIN jack of the power supply into the power connector on the back of the

programmer. This jack is keyed and cannot be inserted incorrectly.

Note: Power supplies for Plus 48, Optima, Optima Light and Dual

are not interchangeable.

For Quad and Octal programmers: Connect the main power cord to the

power jack on the back of the programmer.

5. Insert the other end of the power cord into a 100-250 Volts, 50-60 Hz AC outlet.

Warning: Do not turn on the power