OptimaUserManual.pdf - 第140页
SINGLE, GANG , AND SW AP PROG RAMM ING Opti ma User M anual 134 2. Sel ect one of the installed TOPs on the programmer. Th e p ro gra mmer will the n se lec t all of t he TO P s t ha t ma tc h t he on e c hos en . T he i…
SINGLE, GANG, AND SWAP PROGRAMMING
Optima User Manual
133
Processing Devices in the Swap Programming Mode
In some cases the swap-programming mode further increases efficiency in a
production environment. The swap mode is a modified gang mode, because it allows
you to load, unload, and label devices on half of the TOPs on the programmer while
the other half programs devices. As in gang programming, swap programming
requires that you have at least two identical TOPs installed on your Multisyte
programmer.
A Quad programmer with four TOP48s installed for swap programming
To enter the swap programming mode, perform the following:
1. Select the <swap> button.
The LED beside it will turn yellow, indicating it is waiting for some user action.
SINGLE, GANG, AND SWAP PROGRAMMING
Optima User Manual
134
2. Select one of the installed TOPs on the programmer.
The programmer will then select all of the TOPs that match the one chosen. The
indicator beside the <swap> button will turn green, indicating that the
programmer is ready for operation in the swap mode.
3. In the Status section of the screen, enter the total number of devices to be
programmed in the text field labeled “total.”
Note: If the total number of devices to program is smaller than the
number of sites on the programmer, then the swap mode will
not be activated. The purpose of this mode is to enhance
productivity when processing a large number of devices.
The swap mode is purposely deactivated when processing
small quantities of devices.
4. From the Device Menu, select Program, or select <Program> to begin the
programming operation.
5. A window will appear instructing you to insert devices into the sockets with
flashing indicators; insert the devices, then select <OK>.
6. While the first set of devices is being programmed, other sets may be prepared,
labeled, etc.
7. When the programming of the first set of devices is complete, the software will
instruct you to remove the programmed devices, insert the new devices, and
select <OK>; the removed devices can then be labeled, prepared, etc.
SINGLE, GANG, AND SWAP PROGRAMMING
Optima User Manual
135