OptimaUserManual.pdf - 第12页

INTRO DUCT IO N Opti ma User M anual 6 4. Install the pow er supply : x For Plus 48, Opti ma, Optim a Li ght, and Dual prog rammers: Insert the small DIN jack of the power supply into the power connector on the back of t…

INTRODUCTION

Optima User Manual

Installing the Optima Hardware

Optima programmers arrive with the following components:

x Programmer base

x Optional TOPs

x 25 pin, 1:1 parallel cable, 32” length

x Optima-Booster

x Power cord

x Power supply (Plus 48, Optima, Optima Light, Dual)

x Optima Windows software on CD-ROM

x Optima User Manual

To prepare the Optima programmer for use, remove all the components from the

packaging material and verify that they are in good repair.

Connecting the Programmer to Your Computer

Connect the programmer to your computer by following these steps:

1. Make sure that both the computer and programmer power switches are turned

OFF.

2. Connect one end of the parallel cable to the port on the rear of the programmer.

3. Connect the other end of the parallel cable to the parallel port of your computer.

If your computer has more than one parallel port, any empty port may be used.

Note: Some parallel ports have hardware characteristics that may

cause problems communicating with the programmer. If you

see the message “Found slow printer port” during

installation, install the Optima-Booster supplied with your

programmer. Follow the instructions “Installing the

Optima-Booster for a Slow Printer Port.”

INTRODUCTION

Optima User Manual

4. Install the power supply:

x For Plus 48, Optima, Optima Light, and Dual programmers: Insert the small

DIN jack of the power supply into the power connector on the back of the

programmer. This jack is keyed and cannot be inserted incorrectly.

Note: Power supplies for Plus 48, Optima, Optima Light and Dual

are not interchangeable.

For Quad and Octal programmers: Connect the main power cord to the

power jack on the back of the programmer.

5. Insert the other end of the power cord into a 100-250 Volts, 50-60 Hz AC outlet.

Warning: Do not turn on the power

INTRODUCTION

Optima User Manual

Connecting the TOPs to Your Programmer

Programmers come with a variety of TOPs. If the TOP that came with your

programmer is not already installed, install it now following these steps:

1. Turn the TOP over and examine the pins to verify that they are straight.

2. Hold the TOP at a 45q angle to the programmer base, with the plastic tab of the

TOP hooked into the receiving indentation of the base.

3. Lower the TOP until it rests lightly on the base.

4. Rock the TOP gently until it seats into the base.

5. Press the TOP gently until you hear a click.

Warning: Do not press the TOP if you meet resistance. The pins

may not be properly lined up with the pin connector strip

on the base. If you meet resistance, remove TOP and

begin again at Step 1.

Note: You can arrange the TOPs in any order you want. It is

common to arrange similar TOPs close to each other.

6. Turn the power switch on the back of the programmer to the ON position.

7. Turn the power switch on your computer to the ON position.