ALFeeder_E.pdf - 第102页

3. Maintenance / Replacing procedure 4-14 Chapter 4 Maintenance and parts replacement 3.6 Electrical connecting section 3.6.1 Replacing board connector 1 Detach board connector . 1. Remove 2 screws moun ting bo ard conn …

100%1 / 112
3. Maintenance / Replacing procedure
4-13
Chapter 4 Maintenance and parts replacement
3.5.2 Replacing tail pin
►
Attaching tail pin using jig
Using a tail pin attachment jig (KHJ-ME101-00X JIG, TAIL PIN) is recommended.
1
Detach tail pin.
Remove 2 bolts mounting tail pin with hex
wrench (2.5) and pull out tail pin from feeder
body.
2
Attach tail pin to be replaced.
1. Install 2 bolts temporarily with hex wrench
(2.5) to attach tail pin to be replaced to
feeder body.
2. Open clamp lever assembly and set tail pin
attachment jig.
3. Tighten 2 bolts for tail pin fully with hex
wrench (2.5).
• Tightening torque: 55 N·cm
c
CAUTION
Attaching tail pin obliquely may make feeder difficult to
attach/detach.
►
Attaching tail pin without jig
When tightening 2 bolts for tail pin fully, press
tail pin in arrow's direction shown in the figure
on the right.
Step 1
Detaching tail pin
Tail pin
Mounting bolts
Under plate
63416-KLU-30
Step 2
Attaching tail pin
Bolts mounted
temporarily
Jig touches here
Tail pin
attachment jig
63417-KLU-30
Attaching tail pin without jig
Bolts mounted temporarily
Push tail pin in
arrow’s direction.
Hex wrench
63418-KLU-30
3. Maintenance / Replacing procedure
4-14
Chapter 4 Maintenance and parts replacement
3.6 Electrical connecting section
3.6.1 Replacing board connector
1
Detach board connector.
1. Remove 2 screws mounting board connector
to EL box with Phillips screwdriver.
2. Pull out board connector forward.
c
CAUTION
Do not touch terminal inside of board connector.
2
Attach board connector.
1. Align new board connector with EL box
mounting groove and insert it.
2. Apply thread lock (LOCTITE 241) to 2
screws an tighten them with Phillips
screwdriver.
• Tightening torque: 30 N·cm
►
Clean board connector.
Remove dust and dirt with vacuum tool (option)
or small vacuum cleaner.
Step 1
Detaching board connector
Screw
EL box
Board connector
63419-KLU-30
Cleaning board connector
Board connector
Vacuum tool or
small vacuum cleaner
63420-KLU-30
3. Maintenance / Replacing procedure
4-15
Chapter 4 Maintenance and parts replacement
3.7 Operation section
3.7.1 Replacing handle
1
Remove handle pin.
Detach E-ring for handle pin mounting handle
with precision screwdriver.
c
CAUTION
Make sure not to lose E-ring when detaching it.
2
Detach handle.
Loosen 1 bolt mounting handle with hex wrench
(2.5) to detach handle from feeder body.
3
Attach handle.
Attach handle in reverse order of Step 1 to
Step 2.
• Tightening torque: 100 N·cm
Step 2
Detaching handle
Mounting bolt
Handle
63422-KLU-30
Step 1
Removing handle pin
E-ring
Handle pin
63421-KLU-30