ALFeeder_E.pdf - 第87页

4. T roubleshooting 3-41 Chapter 3 Setting up 4.6 Feeder Guide type is incorr ect. █ Error : Feeder does not operate as error message "AL feeder guide size mismatch err or" is displayed. ► Cause Request type of…

100%1 / 112
4. Troubleshooting
3-40
Chapter 3 Setting up
4.5.1 Checking sensor status
When the component tape cannot be loaded/unloaded even after performing countermeasures previously
described, open [Unit] - [Feeder] screen to check if sensors operate correctly.
►
Exit Sensor
Detach the tape guide and press the sensor with finger.
►
Middle Sensor
Insert a component tape from the rear of Auto loading feeder (loading unit side) 15 cm or more.
►
Entrance Sensor
Set a component tape to the loading unit.
c
CAUTION
Make sure to return the detached tape guide to the original position after checking sensor.
Checking sensor status
ON : Component tape is detected.
OFF : Component tape is not detected.
Loading unit
64312-KLU-30
4. Troubleshooting
3-41
Chapter 3 Setting up
4.6 Feeder Guide type is incorrect.
█
Error : Feeder does not operate as error message "AL feeder guide size mismatch error"
is displayed.
►
Cause
Request type of tape guide on board data and actual type of tape guide attached to Auto loading
feeder are different.
►
Countermeasure
Check the attached component and the type of tape guide to be used (2S/S/M/L/LL). Then replace the
feeder with one that type is same as request type of tape guide .
LED1
LED2
LED3
FEED
BACK
FUNC
LOAD
Feeder Guide type is incorrect.
Tape guide type is not same as feeder type
Types are different.
Cause of error
Tape guide type (M)
Request type of tape guide type (S)
64307-KLU-30
Chapter 4 Maintenance and parts
replacement
Contents
1. Maintenance 4-1
1.1 Maintenance sections/Replaceable parts 4-1
2. Preparation for maintenance 4-2
2.1 Required tools 4-2
2.2 Maintenance sections 4-2
2.3 Replaceable parts 4-3
3. Maintenance / Replacing procedure 4-5
3.1 Tape guide 4-5
3.1.1 Cleaning 4-5
3.1.2 Replacing tape guide assembly 4-7
3.2 Maintaining tape guide assembly 4-8
3.2.1 Cleaning tape path/Replacing leaf spring 4-8
3.2.2 Replacing pusher assembly 4-9
3.2.3 Replacing discharge assembly 4-9
3.3 Front block 4-10
3.3.1 Replacing front block 4-10
3.4 Connecting section for feeder bank 4-11
3.4.1 Replacing under rail 4-11
3.4.2 Replacing reel holder bracket 4-11
3.5 Clamp section 4-12
3.5.1 Replacing clamp lever assembly 4-12
3.5.2 Replacing tail pin 4-13
3.6 Electrical connecting section 4-14
3.6.1 Replacing board connector 4-14
3.7 Operation section 4-15
3.7.1 Replacing handle 4-15
3.8 Loading unit 4-16
3.8.1 Replacing clamp units 4-16
3.9 Preset holder section 4-17
3.9.1 Replacing sliding stopper 4-17